Miniatures 59057 Assembly Instructions

#59057/9057X
Classic Room Box Kit
by Houseworks Ltd.
Step-by-step assembly instructions
Copyright miniatures.com 2021, 2025
PARTS LIST:
Back Wall
Floor/Ceiling (2)
Side Wall (2)
Acrylic Pane
Cove Mouldings (4)
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
100 Grit Sandpaper
Primer/Sealer
Assembly Instructions
Tip: Plan the finishes for the interior and exterior at the
dry-fit stage, before final/permanent assembly. It is eas-
ier to finish the panels as flat surfaces. Disassemble and
finish as desired, then reassemble using glue.
1. Start with the back wall and a
floor/ceiling piece. Stand the
pieces on edge so that the long
joint is vertical. Apply tape across
the joint with the back piece out-
side, over the edge of the floor/
ceiling pieces and flush along
the edge. Tape the next joint
like the first, back piece over the
edge of the floor/ceiling piece.
From the inside of the box, open
the taped joints and apply glue
along the length of the edge
of the floor/ceiling piece (Fig 1.).
Fold the joints closed again and
add tape if needed. Clean away
any excess glue.
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com • Made in Thailand
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts List.
• Thoroughly read the directions before starting.
• Set up a dedicated work area to avoid the need to unpack,
repack, or move the project frequently.
• Use a clean, level, and dry work surface protected from glue spills.
• Dry fit the parts using masking tape to ensure everything aligns
correctly before permanent assembly.
2. With the box still on end, apply glue
Back
Floor/Ceiling
3. Dry fit cove mouldings to be
Fig. 1
Not Suitable for Children
under 15 years old.
to the three joined panel edges (Fig.
2) and set an end wall in place on top,
making sure the edges are flush on
the back and sides. There is a slight
overhang at the front. Secure with
masking tape and clean away any
excess glue.
Turn the box over, glue the other
end wall in place and tape securely.
Clean away any excess glue.
sure of how they fit around
the box. Some sanding inside
the routed channels may be
necessary to allow the side
pieces to slide easily over
the side wall edges. The
bottom cove moulding fits
flush against the front edge
of the floor.
WARNING:
CHOKING HAZARD — Small parts
Fig. 2
0225