Warnings This product is designed for users with special needs. For indoor use only. This product uses a power supply. Do not use any other power cord than the one supplied. Before plugging in the power cord, please confirm it is the cord supplied with your product. Using any other power cord than the one supplied could supply an incorrect voltage which can cause damage to the product or blow a fuse.
Installation The illustrations provided are showing a typical method using screws and hardware for a solid brick wall. Step 1 The 6 mirror plates should to be attached to the mirror back. Using the Diagram A for mirror plate placement, mark 0.25" (6mm) in from the edge (Diagram B). Fasten the mirror plates to the mirror back using the supplied 4G x 3/4 Inch (19 mm) screws and a Phillips or Posi head screwdriver.
Connecting Power The mirror uses a Lightsource that requires an electrical outlet. The cord to the Lightsource is attached to the back of the mirror. Connect the cord to the outlet. When turned on, it will run through a color sequence until it is turned off. Fiber optics are not glass.
Information about products that generate electrical noise USA and Canada This device complies with FCC and industry Canada RF radiate exposure limits set forth for general population. It must not not be co-located or operating in conjunction with any other antennas or transmitters.
Guarantee CONDITIONS OF GUARANTEE This guarantee is in addition to and does not in any way affect any statutory or other rights of consumer purchasers .If within the applicable guarantee period (as shown in 8 below) the appliance proves to be defective by reason of faulty design, workmanship or materials, we undertake subject to the following conditions to have the defective appliance (or any part or parts thereof) repaired or at our discretion replaced free of charge.
Technical Electrical information Table 1 Supply Voltage 110 / 240 Power Supply Primary Voltage 110 / 240 Power Supply Secondary Voltage Power Supply Current Rating Power Supply Plug top Fuse Working Load Current Power Supply Compliance EN-FCC Complies to: BS EN 60355-1 Generic EMC standards - Emission standard for residential, commercial and light-industrial environments Mirror: 59.5"H x 48"W x 4.3"D...
Need help?
Do you have a question about the SpaceKraft SP7286 and is the answer not in the manual?
Questions and answers