Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Miele KM 390
Summary of Contents for Miele KM 390
- Page 1 Operating instructions Gas hobs KM 390 KM 391 To avoid the risk of accidents or damage to the appliance, it is essential to read these operating instructions before it is installed or used for the first time. M.-Nr. 05 827 461...
-
Page 2: Table Of Contents
Contents Description of the appliance ......... 3 Appliance models . -
Page 3: Description Of The Appliance
Description of the appliance Appliance models KM 390 a Wok ring Control knob for cooking zone: b Wok burner i Front right c Auxiliary burner j Rear right d Fast burner k Rear middle e Normal burner l Rear left... - Page 4 Description of the appliance KM 391 a Wok burner Control knob for cooking zone: b Wok ring i Front right c Auxiliary burner j Rear right d Fast burner k Rear middle e Normal burner l Rear left f Mains connection cable m Front left Depending on country of destination, the appliance may be supplied with...
-
Page 5: Burner
Description of the appliance Burner Wok burner Auxiliary, normal and fast burner n Burner cap o Burner ring p Burner head q Burner base r Ignitor s Ignition safety device... -
Page 6: Warning And Safety Instructions
Warning and Safety instructions The electrical safety of this This appliance complies with all appliance can only be guaranteed relevant legal safety requirements. when continuity is complete between it Improper use of the appliance can, and an effective earthing system which however, present a risk of both complies with local and national safety personal injury and material... -
Page 7: Correct Usage
Warning and Safety instructions Correct usage Make sure all the components of the gas burners have been For safety reasons the appliance correctly assembled before switching must only be operated after it has been built in. This is necessary to ensure that all electric components are When using a cooker hood over shielded. - Page 8 Warning and Safety instructions Safety with children Keep all pans out of reach of children. Turn pan handles inwards The appliance is only intended for away from the edge of the hob. Danger use by adults who have read these of burning or scalding.
- Page 9 Warning and Safety instructions Protecting the appliance from Stainless steel surfaces: damage Avoid allowing liquids or foods containing salt to spill onto a Do not use a steam cleaner to stainless steel hob or trim. If salty foods clean this appliance. The steam or liquids do get on the hob, they could reach electrical components and should be removed as soon as possible...
- Page 10 Warning and Safety instructions Protection from burning and Remove splashes of fat and other food debris from the surface as scalding soon as possible. These are a fire The surface of the appliance gets hazard. hot when in use, and remains hot Never leave the appliance for quite a while after being switched unattended when cooking with oil...
- Page 11 Warning and Safety instructions With a damaged appliance Further safety notes In the event of damage or a defect, When using an electric socket near switch off the appliance immedi- the appliance, care should be ately. Turn off the gas supply tap, and taken that the cable of the electrical disconnect completely from the appliance does not come into contact...
-
Page 12: Caring For The Environment
Caring for the environment Disposal of the packaging Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled. -
Page 13: Before Using For The First Time
Before using for the first time General notes Cleaning and heating up for the first time A data plate for your appliance is supplied with this documentation. It Before using for the first time clean the should be stuck into the space hob and all removable parts as follows: provided at the end of the instruction ^ The removable parts of the gas... -
Page 14: Using The Gas Hob
Using the gas hob Switching on, controlling, The burners can only be switched switching off on by pressing in the appropriate The control knobs are used to switch on control and turning it anti-clockwise, the burner and regulate the strength of and switched off by turning the the flame. - Page 15 Using the gas hob Controlling: Switching off: ^ When the flame burns steady after ^ Turn the knob clockwise until the "ß" releasing the knob, select a setting position is reached. between the large and the small This stops the flow of gas and the flame flame symbol.
-
Page 16: Settings
Using the gas hob Settings Setting Auxiliary-, nromal- Wok burner and fast burner ß gas supply is turned off strong flame outer ring: strong inner ring: strong & outer ring: weak inner ring: strong (2x) outer ring: inner ring: strong weak flame outer ring: inner ring:... -
Page 17: Suitable Pans For Gas Burners
Using the gas hob Suitable pans for gas burners – Pans with thick bases are preferable as these distribute heat more evenly, Burners Min. pan base and therefore lessen the risk of heat diameter in cm spots occurring which can cause food to stick or burn. -
Page 18: Safety Cut-Out
Using the gas hob Safety cut-out Use during a power cut This appliance is fitted with an electric If there is an interruption to the ignition safety device which cuts off the electricity supply the gas can be supply of gas to a burner if the flame ignited with a match: goes out, for example if food has boiled ^ Press in the relevant control knob and... -
Page 19: Cleaning And Care
Cleaning and care General Pan support, Control knobs Clean the appliance regularly, Take off the pan supports. preferably after each use. Allow it to Clean these and the control knobs with cool sufficiently. a damp cloth, washing up liquid and warm water. -
Page 20: Hob Surface
Cleaning and care Hob surface Ceramic surface Wipe soiling off using a damp cloth. Stainless steel Stubborn soiling is best removed with a shielded scraper blade. Clean the hob surface with a sponge and a mild solution of warm water and Then apply a proprietary cleaning washing up liquid. -
Page 21: Burners
Cleaning and care Burners The surface of the burner cover will gradually become more matt with time. The burners can be dismantled for This is quite normal and will not affect cleaning. the operation of the hob. ^ Wipe the fixed parts of the burner Proceed as follows: base with a damp cloth and dry ^ Take off all the removable parts of the... - Page 22 Cleaning and care Re-assemble the auxiliary, normal and fast burners as follows: ^ Make sure that all the locating tabs and notches line up exactly. Place the burner head p on to the burner base q so that the ignitor r and the ignition safety control s extend through their respective holes in the burner head.
- Page 23 Cleaning and care Re-assemble the wok-burner as follows: ^ Make sure that all the locating tabs and notches line up exactly. Place the burner head p on to the burner base q so that the ignitor r and the ignition safety control s extend through their respective holes in the burner head.
-
Page 24: Problem Solving Guide
Problem solving guide ... the gas flame goes out after being Repairs to the gas and electrical lit? components of this appliance must Check whether the burner cover is only be carried out by a suitably correctly assembled. qualified and competent person to ensure safety. -
Page 25: Gas Connection
Gas connection Depending on country of destination Connection to the gas supply, or this appliance is set up for connection conversion from use of one type of to natural or liquid gas (see adhesive gas to another should only be label on the appliance). -
Page 26: Electrical Connection
Electrical connection All electrical work should be carried out Important: by a competent person, in strict The wires in the mains lead are accordance with national and local coloured in accordance with the safety regulations. following code: For extra safety it is advisable to install Green/yellow = earth a residual current device (RCD), with a Blue... -
Page 27: After Sales Service
After Sales Service The address of the nearest Service Department is given on the back page. The voltage and rated load are given on the data plate. Please quote these data, together with the model description and serial number when contacting the Ser- vice Department. - Page 28 Alteration rights reserved / 0605 M.-Nr. 05 827 461 / 01 en - AUS...
Need help?
Do you have a question about the KM 390 and is the answer not in the manual?
Questions and answers