HP NetStorage 6000 Replacement

H P N E
Power Supply Replacement
NOTES:
• To insure proper air flow, leave the power supply in the unit until you are ready to install the
replacement.
• You can change one power supply at a time while the HP NetStorage 6000 is operating.
Locate the Failed Power Supply
Remove the Failed Power Supply
T S T O All manuals and user guides at all-guides.com R
A. If an alarm is sounding, press the alarm-reset button
on the front panel.
B. Locate the blinking red LED on the back panel. This LED identifies
the failed power supply.
NOTE:
fully seated in the unit. Make sure the power supply latch is in its
fully upward position.
A. Push down on the failed power supply's latch, and carefully pull
the power supply out of the unit as shown.
A G E 6
Parts Required:
• One power supply
• Electrostatic protection device
If no LED is flashing, then the power supply may not be
0 0 0