Subscribe to Our Youtube Channel
Related Manuals for Ardisam CAGE RD30
Summary of Contents for Ardisam CAGE RD30
- Page 1 Owner’s Manual CAGE PERMANENT HUB BLIND ® RD30 MODEL CRD30B P/N: 46263 Get parts online at © 2025 Ardisam C/N: 48223 www.cageblinds.com All Rights Reserved REV1: 01/01/2025...
-
Page 2: Warranty
Ardisam will void your warranty and waive any and all claims for liability against the manufacturer Ardisam. If you choose to elevate this product on a Ardisam, Inc. tower structure, the warranty listed in the tower structure manual will apply to this product in addition to the warranty statement in this owner’s manual. -
Page 3: Inspection And Maintenance
• Do not store flammable liquids inside a tent Proper securing of blind is necessary to avoid damage Only use approved Ardisam parts. Failure to do so to blind due to high winds or unattended use. may result in serious injury or death! -
Page 4: Illustrated Parts Breakdown
Owner’s Manual CAGE RD30 Permanent Hub Blind ILLUSTRATED PARTS BREAKDOWN Check for parts online at www.cageblinds.com or call 800-345-6007... -
Page 5: Parts List
Owner’s Manual CAGE RD30 Permanent Hub Blind PARTS LIST ITEM PART NO. DESCRIPTION 46250 ROOF HUB ASSEMBLY W/O EYEBOLT 37113 WALL HUB ASSEMBLY 43929 TOP CORNER HUB ASSEMBLY 36283 FIBERGLASS POLE ASSEMBLY 12MM X 45.6 IN 35791 HORIZONTAL SPREADER POLE ASSEMBLY... - Page 6 Owner’s Manual CAGE RD30 Permanent Hub Blind 1. Remove the blind from the carry bag. 2. Lay the blind flat on the ground so one (1) of the hub wall panels is facing upward. Be completely sure there is no material twisted or overlapping the ends of any feet.
- Page 7 Owner’s Manual CAGE RD30 Permanent Hub Blind 5. Remove the spreader poles from carry bag and sort into two groups; (4) Vertical Spreader Poles (with pegs) (4) Horizontal Spreader Poles (with discs) 6. You will start assembly with the four (4) vertical spreader poles with the round peg ends.
- Page 8 Owner’s Manual CAGE RD30 Permanent Hub Blind 9. Repeat steps 6 & 7 for the remaining two (2) corners. All four (4) vertical spreader poles should be installed. Ensure all four clamps are in the locked position. SEE FIGURE 6.
- Page 9 Owner’s Manual CAGE RD30 Permanent Hub Blind 11. Insert the other end of horizontal spreader pole into the slot of the opposite top corner hub. SEE FIGURE 8. Note: Slight rotation of the spreader pole will help with full engagement of each pole end into the slots.
- Page 10 Owner’s Manual CAGE RD30 Permanent Hub Blind 13. On each roof pole there is an adjustable tensioning handle. These tension the roof and fabric. Place your left hand on the smaller pole closest to the corner hub. Then place your right hand on the tensioner.
- Page 11 Owner’s Manual CAGE RD30 Permanent Hub Blind 15. Go back to the four (4) horizontal spreader poles; while spreading them apart, flip clamp lever into the LOCKED position. SEE FIGURE 11. Once all the horizontal spreader NOTE: MAKE SURE poles are locked, go back to the...
- Page 12 Warning labels in some product images may have been removed for photography or demonstration purposes only. Props shown in photos not included. Some assembly may be required. Refer to product manual/instructions for safe setup and use. Rivers Edge Treestands®, A Division of Ardisam, Inc. 1730 Industrial Avenue, Cumberland, WI 54829...
Need help?
Do you have a question about the CAGE RD30 and is the answer not in the manual?
Questions and answers