Ardisam TERRITORY TENTS JET SET CT400DB Assembly And Use Instructions

4-person tent

Advertisement

JET SET 4-PERSON TENT
ASSEMBLY AND USE INSTRUCTIONS
WARNING
READ AND UNDERSTAND ALL ASSEMBLY, INSPECTION, & USE INSTRUCTIONS PROVIDED BEFORE EACH USE. FAILURE TO
FOLLOW INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
NEVER ALLOW CHILDREN TO PLAY IN THIS PRODUCT UNATTENDED.
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
THIS TENT IS MADE WITH FLAME RESISTANT FABRIC WHICH MEETS CPAI-84 SPECIFICATIONS. IT IS NOT FIREPROOF. THE
FABRIC WILL BURN IF LEFT IN CONTINUOUS CONTACT WITH ANY FLAME SOURCE. THE APPLICATION OF ANY FOREIGN
SUBSTANCE NOT THE TENT FABRIC MAY RENDER THE FLAME RESISTANT PROPERTIES INEFFECTIVE.
THE USE OF ELECTRICAL DEVICES IS NOT RECOMMENDED INSIDE THE TENT.
40766 | REV1 10/13/2022 | © Copyright 2022 Ardisam, Inc. | All Rights Reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TERRITORY TENTS JET SET CT400DB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ardisam TERRITORY TENTS JET SET CT400DB

  • Page 1 FABRIC WILL BURN IF LEFT IN CONTINUOUS CONTACT WITH ANY FLAME SOURCE. THE APPLICATION OF ANY FOREIGN SUBSTANCE NOT THE TENT FABRIC MAY RENDER THE FLAME RESISTANT PROPERTIES INEFFECTIVE. THE USE OF ELECTRICAL DEVICES IS NOT RECOMMENDED INSIDE THE TENT. 40766 | REV1 10/13/2022 | © Copyright 2022 Ardisam, Inc. | All Rights Reserved.
  • Page 2 BEFORE YOU BEGIN • Locate a level site clear of all debris and sharp objects to prevent tears while setting up your tent. • For easy set-up in windy conditions, make sure to position one of the corners of the tent into the wind. •...
  • Page 3 SET-UP INSTRUCTIONS CONT. 3. Find the webbing loop handle located on the exterior of each hub, centered on each wall. Proceed to pull outward until the wall pops open. Do this to all SIDE WALLS first. (SEE FIGURE 3) NOTE: For added assistance, grasp the top seam of the panel and place your foot on the bottom edge when popping open a side wall panel to help hold the tent in place.
  • Page 4 ATTACHING THE RAIN FLY 1. The tent must be free standing with all four (4) walls popped out and the ROOF COLLAPSED. (SEE FIGURE 7) NOTE: It’s important that the roof is collapsed to prevent bending of pole ends. 2. Slide the rain fly loosely over the tent roof. The short connecting poles should be on the underside of the rain fly.
  • Page 5 90 days after purchase. For the warranty to be valid, the product must be registered by filling out the warranty card and it must be received by Ardisam, Inc., within 30 days of purchase. Ardisam, Inc. shall not be obligated to ship any repair or...
  • Page 6 TERRITORY TENTS®, A DIVISION OF ARDISAM, INC. 1730 Industrial Avenue, Cumberland, WI 54829 | 800-345-6007...

Table of Contents