Tektronix 3A74 Calibration Procedure page 2

EQUIPMENT REQUIRED
All TEKTRONIX test equipment must be calibrated to Factory Test Limits
using methods specified in the applicable TEKTRONIX Factory Calibration
Procedure. Other test equipment should be calibrated to its manufacturer's
specifications. Exceptions to calibration procedures, which are necessary
to improve the measurement capability of some test equipment, e.g. calibrated
to +0.5% accuracy at some specific setting, are noted on this Equipment
Required List.
Equivalent test equipment may be used. A Test-Final Staff Engineer must
approve any substitutions.
Qa. THKTRONIX Instruments
TYPE 561B OSCILLOSCOPE
TYPE 2B67 TIME BASE PLUP-IN
TYPE 545B OSCILLOSCOPE
TYPE 1Al VERTICAL PLUG-IN
TYPE 106 SQUARE-WAVE GENERATOR
TYPE 191 CONSTANT-AMPLITUDE SIGNAL GENERATOR
P R E R R P
Caltbratton Ftxtures and Accessortes
>
P6008 10X Probe (010-0129-00)
P6011 1X Probe (010-0074-00)
Low Frequency Sine-Wave Generator (LFSWG) (067-0542-99)
Standard Amplitude Calibrator (SAC) (067-0502-00)
Line Voltage Control Unit (TU-76) (067-0048-00
47pF Input Normalizer (067-0541-00)
502 BNC Termination (011-0049-00)
502 BNC Coaxial Cables (012-0057-01)
Micro-shock Hammer (Dwg. #1283-B)
560-Series Plug-In Exten. (013-0034-00)
GR to BNC female Adapter (017-0063-00)
P R E R P W R P R P R P P R P R e
e. Other Manufacturer's Equipment
1 20,0002/VDC Multimeter
July 1969 ~ 3A74