Superuniti Installation And Connection; Superuniti Rear Panel; Mains Power Connection; Fm/Dab Aerial Connection - NAIM SUPERUNITI - Manual

SuperU niti Insta l la ti on and Connec tio n
2 Super Uniti I nsta lla t io n a nd C onnecti on
Your SuperUniti should be installed on an equipment stand intended for the purpose.
Ensure it is well ventilated, and do not stand it directly on top of another item of
equipment. It should be installed in its final location before connecting cables or switching
on. The SuperUniti has no standby mode and is intended to be left switched on.
Connecting the SuperUniti to mains power and to a variety of audio peripherals and
sources is described in the following paragraphs. Diagram 2.1 illustrates the SuperUniti rear
panel connection sockets.
2. 1 S up erUn it i Rear P an e l
power switch
mains input
and fuse
2. 2 M ains P owe r C o n n e ct io n
Connect the SuperUniti to a mains power socket using
either the mains cable supplied or a Naim Power-Line.
2. 3 F M/ D A B A e rial Co n n e c t io n
The SuperUniti FM/DAB module will only be able to provide
high quality FM and DAB radio if a strong, interference-
free radio signal is available. The SuperUniti rear panel FM/
DAB Aerial socket must be connected, via 75 Ohm low-
loss coaxial cable, to a suitable aerial. The aerial should
be mounted clear of large obstructions and as high as
possible; ideally on a roof.
Note:
Your local retailer should be able to offer advice on
a suitable aerial and aerial installer.
2
left right upgrade interface
speaker speaker
signal ground switch
wireless network
(Wi-Fi) antenna socket
remote
mini-USB in/out
subwoofer
preamp output
output
2 . 4 A u d i o I n p u t s a n d O u tp u ts
2.4.1 Audio Signal Inputs
SuperUniti provides four stereo analogue inputs and six
S/PDIF digital inputs including one combined analogue/
digital input socket. Connection to the inputs is made via
a variety of socket types. The following table lists the inputs
and their socket type:
Input Type
an. 1 Analogue
an. 2 Analogue
an. 3 Analogue
front panel Analogue
Digital
dig. 1 Digital
dig. 2 Digital
dig. 3 Digital
dig. 4 Digital
dig. 5 Digital
Note: The front panel analogue/digital jack socket can
accept both conventional analogue 3.5mm plugs and
mini-TosLink optical digital plugs. It will automatically
identify the type of plug inserted and handle the signal
appropriately.
Always use high quality interconnect cables to connect
sources to SuperUniti inputs.
network socket digital
digital output inputs
analogue
DAB/FM aerial
inputs socket
Socket
5-pin DIN
RCA phonos
RCA phonos
3.5mm jack
3.5mm mini-TosLink jack
Coaxial (BNC)
Coaxial (RCA phono)
Optical (TosLink)
Optical (TosLink)
Optical (TosLink)