NAIM FLASH REMOTE HANDSET Manual page 10

3. Note the orientation of the
chamfer with a dot located on one side of the PIC. The
replacement
4. Attach an anti-static earth strap to your wrist and connect the
crocodile clip to the top negative battery terminal (connected to
the black wire).
5. You will notice two recesses on opposite corners of the
Socket. Place the small barbed end of the
into one of the recesses in the corner of the
the PIC partially out of its socket. Place the barbed end into the
opposite recess and lever the
6. Place the replacement
CORRECT ORIENTATION. Apply mild pressure to push the
into the socket so that it is flush to the top of the socket.
7. Replace the batteries and rear cover. Your Flash display should
now show the enhanced display format.
8. Your Flash handset has now been updated.
PIC
PIC must be inserted with the same orientation.
PIC squarely into the socket.
in the PIC Socket. There is a
PIC
PIC
PIC fully out of the socket.
8
PIC
extraction tool
Socket. Lever
ENSURE
PIC