Introduction
The SR230M is a stand-alone, fully supervised outdoor wireless siren with a built-in strobe light and wireless transceiver.
It uses two-way wireless communication, ensuring continuous supervision between the panel and siren, and delivers
rapid response to alarm signals within two seconds. It features the latest Gaussian Frequency Shift Keying (GFSK)
technology with frequency and encryption hopping. This ensures superior wireless range, enhanced encryption,
supervision, and reliability. The SR230M typically offers lens color options, such as red, blue, and amber.
Quick Installation - Experienced Installers
To install SR230M:
NOTE: Opening the cover (Tamper) will not trigger an audio alarm. The audio alarm will be triggered only if the SR230M
is registered to the Armed status system. In Disarmed status, tamper events—such as cover removal or detachment
from
the
wall
1. Open the siren and remove the batteries.
2. Fix the backplate.
3. Insert the batteries.
4. Pair SR230M with the console (Using the BlueEye application):
•
Go
to:
NOTE: You can instantly pair SR230M by pressing the Learn button, or by opening the tamper.
5. Configure SR230M (Using the BlueEye application):
•
Go to: Hardware > Tap SR230M from the device list > Enter the necessary details > Save.
Built-in status indications of SR230M:
Status LED
•
Flashing red 5 times - Power up sequence
LD2
•
Red blinking (5 times) - Not connected to the console; the device is defaulted (new or unpaired).
•
Green blinking (5 times) - Connected to the console; the device is paired.
—will
send
a
Hardware
>
Tap
+
Version - 1.0
CMS
report
on
the
top-right
of
1
and
a
push
the
page
>Auto
learn
notification.
devices.
Need help?
Do you have a question about the SR230M and is the answer not in the manual?
Questions and answers