Castex UV-3000 Operator And Parts Manual

Wide area vacuum

Advertisement

Quick Links

Model No.:
607425
TENNANT COMPANY
701 NORTH LILAC DRIVE
MINNEAPOLIS, MN 55422
MAILING ADDRESS:
TENNANT COMPANY
P.O. BOX 1452
MINNEAPOLIS, MN 55440–1452
CASTEX CUSTOMER SERVICE:
1–800–365–6625
FAX: 1–800–678–4240
TECHNICAL SUPPORT:
1–800–522–7839 EXT. 5356
Home
Find... Go To..
UV-3000
Wide Area Vacuum
Operator and Parts Manual
Rev. 01 (03-04)
607585

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UV-3000 and is the answer not in the manual?

Questions and answers

Summary of Contents for Castex UV-3000

  • Page 1 Operator and Parts Manual 607425 TENNANT COMPANY 701 NORTH LILAC DRIVE MINNEAPOLIS, MN 55422 MAILING ADDRESS: TENNANT COMPANY P.O. BOX 1452 MINNEAPOLIS, MN 55440–1452 CASTEX CUSTOMER SERVICE: 1–800–365–6625 FAX: 1–800–678–4240 607585 TECHNICAL SUPPORT: Rev. 01 (03-04) 1–800–522–7839 EXT. 5356 Home Find... Go To..
  • Page 2: Table Of Contents

    1999, 2004 Tennant Company Printed in U.S.A. subsidiaries. Castex is a registered United States trademark of Tennant Company. This machine will provide excellent service. However, the best results will be obtained at minimum costs if: The machine is operated with reasonable care.
  • Page 3: Safety Precautions

    WARNING: Do Not Use Outdoors Or On Wet – All repairs must be performed by a qualified service person. Surfaces. Do Not Expose to Rain. Store Indoors. – Do not modify the machine from it’s original design. UV-3000 (03–04) Home Find... Go To..
  • Page 4: Grounding Instructions

    WARNING LABEL – LOCATED INSIDE OF MACHINE ON VACUUM MOTOR COVER. WARNING: Moving fan blades. Keep away. WARNING LABEL – LOCATED ON BACK- SIDE OF MACHINE. WARNING LABEL – LOCATED ON BACKSIDE OF MACHINE. UV-3000 (03–04) Home Find... Go To..
  • Page 5: Machine Setup

    3. Properly adjust brush height to type of carpet, tilt machine back and turn adjustment knob counterclockwise. Now tilt machine back down to floor and activate triggers. If a slight forward propulsion is noticed, machine is properly adjusted FIG. (Figure 3). UV-3000 (03–04) Home Find... Go To..
  • Page 6: Hose Attachment Operation

    3. Turn brush adjustment knob to “STORAGE” control knob. This will direct vacuum air flow to position and wrap power cord around handle. accessory hose connector (Figure 7). 4. Wipe off entire machine with damp cloth. UV-3000 (03–04) Home Find... Go To..
  • Page 7: Weekly Maintenance

    2. Inspect carpet brush for wear by positioning a rubber bearing blocks have Number “1” showing straight edge across shoe. If bristle extension is (Figure 12). 3 mm (0.13 in) or less, adjust brush (Figure 10). UV-3000 (03–04) Home Find... Go To..
  • Page 8: Belt Adjustment Or Replacement

    Then use a 13 mm wrench to turn motor adjustment nut clockwise until proper tension is attained. Retighten screws (Figure 14). ATTENTION: Upper housing may have to be removed from lower housing to loosen motor screws. UV-3000 (03–04) Home Find... Go To..
  • Page 9: Trouble Shooting

    Brush not adjusted properly. Reset brush adjustment. Worn brush. Adjust or replace. Vacuum motor not Thermal overloads activated due to plug or Inspect and clean. operating. operating. obstruction. Vacuum switch defective. Contact Service Center. UV-3000 (03–04) Home Find... Go To..
  • Page 10: Specifications

    VACUUM MOTOR TWO 1 hp, 1–stage 5.7 in, 120V, 11A, 1320W WATERLIFT AT SEALED ORIFICE 1219 mm (48 in) DECIBEL RATING AT OPERATOR’S EAR, INDOORS ON 74dB(A) CARPET POWER CORD LENGTH 23 m (75 ft) UV-3000 (03–04) Home Find... Go To..
  • Page 11: Electrical Diagrams

    115 VAC, 1 PHASE, 60 HZ, 15 AMP POWER THREE WIRE CABLE TO HANDLE ASSY. VACUUM SWITCH BRUSH MOTOR SWITCH BLACK BLACK VACUUM MOTOR VACUUM MOTOR 6 AMP CIRCUIT BREAKER BRUSH MOTOR BLACK WHITE UV-3000 (03–04) Home Find... Go To..
  • Page 12: Parts List

    PARTS LIST UPPER HOUSING GROUP 43 44 39 41 49 50 UV-3000 (03–04) Home Find... Go To..
  • Page 13 611778 (STANDARD) 579029 NUT, M06 X 1.0 ∇ 57 DHOSE, 3” X 23” BLACK 614130 ASM., HANDLE, BLUE 608252 607571 DECAL, UV-3000 608253 CLAMP, HOSE 4” GEAR ∇ 573042000 DECAL, “CAUTION VAC ON” 039708155 ASM, VAC/GASKET DMOTOR, VAC FAN 613280...
  • Page 14: Lower Housing Group

    PARTS LIST LOWER HOUSING GROUP 3 60 UV-3000 (03–04) Home Find... Go To..
  • Page 15 DPULLEY, 1.625” DIA BRUSH 578413 101107 FRAME, LOWER CHARCOAL 578261000 WASHER, .31 X .83 140356 SCREW, 1/4–20 X 1” 120101 DECAL, CASTEX LOGO WHITE 069767136 CIRCUIT BREAKER, 7 AMP DBEARING 32492 WASHER, FLAT 0.38 039708064 630508 O–RING, 9.2 ID X 12.7 578728 WASHER, M6.1 LOCK...
  • Page 16: Console Group

    130712 140018 WASHER, LOCK INT #10 578430 WASHER, 0.50 SPRING DISC 140504 NUT, CONDUIT LOCK 1/2” 140900 SCREW, 10–24 X .75 TRS PHL DSTRAIN RELIEF 130167 140519 NUT, 10–24 KEP D RECOMMENDED STOCK ITEMS UV-3000 (03–04) Home Find... Go To..
  • Page 17: Options

    DKIT, STANDARD ATTACHMENT 610988 200351014 WASHER, LOCK M4.1 DCHROME HOSE ATTACHMENT 190902 140032 WASHER, #6 FLAT DWAND, TELESCOPIC CHROME DCLIP, WAND 1” – 1–1/2” DIA 605587 573073 ∇ ASSEMBLY INCLUDED IN ASSEMBLY D RECOMMENDED STOCK ITEMS UV-3000 (03–04) Home Find... Go To..

This manual is also suitable for:

607425

Table of Contents