U-Line H-5703 Owner's Manual

H-5703
GRIDWALL TRIANGLE
TOWER
TOOLS NEEDED
Phillips Thin Open End Wrench
Screwdriver (Included)
Triangle Base x 1
1. Thread casters into the bottom of the triangle base
using the enclosed wrench. (See Figure 1)
Figure 1
2. Set each of the three gridwall panels on the ledge
of the inside of the triangle base. (See Figure 2)
NOTE: In order for accessories to hang correctly,
each panel should have the side with the
horizontal bars facing out and vertical bars
facing in.
3. Connect the gridwall panels together by using three
connector clips per corner at the top, middle and
bottom. Tighten screws to secure the end bars of
panels in between each side of the connector clips.
(See Figure 3)
PAGE 1 OF 3
1-800-295-5510
uline.com
PARTS
Caster x 3
ASSEMBLY
Pour le français, consulter les page 3.
Connector Clip
with Screw x 9
Gridwall Panel x 3
Figure 2
Para Español, vea página 2.
Figure 2
Figure 3
0523 IH-5703