Peavey STANDARD PA MIXER-AMP Owner's Manual

OWNER'S MANUAL
POWER AMPLIFICATION SECTION: 260H MODULE
Output Power & 1 kHz @ 117 VAC Line:
1 Rated Power: 130 W RMS@ Rated Load: 4 Ohms
2. Power vs. Load
LOAD IMPEDANCE_9_£_
1
_OHMS
OUTPUT @> 1 % THD 90 140 80 W
IM Distortion: Less than 0.3 % from 0.5 Watt to 100 Watts, typically 0.1 %
THD: Less than 0.1 % from 0.5 Wati to 100 watts from 20 Hz - 10 kHz. typically .05 7o
Frequency Response: ± 1 dB, 20 Hz - 20 kHz @ 1 W, 4 Ohms
Sonsitivity @ Rated Power & Load 700 mV
Input Impedance: 15 k Ohms
PRE AMPLIFIER SECTION:
Input Characteristics: ITone Controls Flat, Volume ® Maximum, Master 12:00}
1. Sensitivity; 4 mV @ 1kHz
2. Input Impodance: 100 k Ohms Unbalanced
3. Noise: 56 dB (Open Circuit}. 60 dB (50 k Ohms}. 66 dB (Short Circuit}
Distortion ^ 1 kHz @ Rated Output: Less than 0.1 % THD
Frequency Response: 3 dB Down © 40 Hz & 20 kHz
Tone Controls: £ 15 dB <§ 50 Hz and 5 kHz
Effects Send Control: Continuously variable each channel
MASTER SECTION:
Tono Controls: ± 15 dB @ 50 Hz. 800 Hz. 10 kHz
Reverh Return Control- Continously variable with footswitch cut-off
Main Output Level: 2.0 V RMS into 10 k Ohms
Effect Output Level: Effects High, 1.0 V RMS into 10 k Ohms;
Effects Low. 0.25 V RMS into 10 k Ohms