Bosch Professional Series Manual

Professional Series
ISC-PDL1-WC30G
© Bosch Security Systems B.V., 2023 www.boschsecurity.com
<4.5 kg (10 lb)
The small
animal immunity
feature was not
investigated by
UL.
58 mm
(2.25 in.)
136 mm
(5.25 in.)
69 mm
(2.75 in.)
2,1 m - 3 m
(7 ft - 10 ft)
-30°C - +55°C (-22°F - +131°F)
For UL, C-UL Listed Installations, the
temperature range is 0°C - +49°C
(+32°F - +120°F), humidity 93%
< 93%
ISC-PDL1-WC30G:
10.500 - 10.525 GHz
<50 mW (peak)
UL, C-UL
Use only a Listed Class 2 Power Limited Source.
For UL, C-UL Listed product installations, the Listed control unit or a Listed
burglary power supply must provide four hours of standby power.
For C-UL applications, install the unit in accordance with Part 1 of the Canadian
Electrical Code.
ISED non-interference disclaimer
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
1. L'appareil ne doit pas produire de brouillage.
2. L 'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
ISED RF Exposure statement
This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20 cm (7.9 inches)
between the radiator and any part of your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Pour se conformer aux exigences de conformité ISED RSS-102 RF exposition, une distance de séparation
d'au moins 20 cm (7.9 pouces) doit être maintenue entre l'antenne de cet appareil et toutes les
personnes. Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec d'autres.
FCC Compliance statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation. Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, this equipment
should be installed and operated with minimum distance 20 cm (7.9 inches) between the antenna and
your body during normal operation. Users must follow the specific operating instructions for satisfying RF
exposure compliance.
F01U261907 | 10 | 2023.01 | 1