Download Print this page

We.lock TouchEBL63 Instructions Manual

Download this manual

TouchEBL63

Need help?

Do you have a question about the TouchEBL63 and is the answer not in the manual?

Page 1 TouchEBL63...
Page 3 English Restarting diagram...
Page 4 applicable size...
Page 5 0-35mm 30-65mm 30mm 40mm 40-60mm 0-20mm...
Page 6 Restart Please use power bank to charge the lock via USB(Type-C)cable,and then unlock the lock via welock APP (must be tightened after installation) RFID Card * 3 wrench *1 Rear handle screw *1...
Page 7 TouchEBL63 1.Open the silicone cover,loosen the screws with phillips screwdriver 3. Pull apart the latch points on the battery case to open the battery cover,install battery. Both front and rear handles can be installed and removed Remove rear handle Take out the screw...
Page 8 Install front handle wrench TIGHTEN 1. Insert the front handle,the screw holes 2.Use a wrench to hold the nut,turn and the scale are on the same side the front handle clockwise to tighten Tighten 3. Turn the steel piece, insert it into 4.Tighten the screws with a the interface, align the screw holes.
Page 10 . Note: not recharging...
Page 11 Download instructions & Watch Videos...
Page 14 Wooden doors,interior doors,entrance doors etc 50-100mm -25℃- 60℃ 100.000 Times Stainless steel+PC Plastic Fingerprint/RFlD card /APP/USB Backup unlock 3*AAABattery 3.6V - 4.5V Replacedble Silver 10-12Months...