We.lock TouchEBL61 Instructions

TouchEBL61
RFID Card * 3
Rear handle
Restart key
3. Pull apart the latch points on the
battery case to open the battery
cover,install battery.
Both front and rear handles can be installed and removed
Front handle
Remove
Installation
Rear handle
screw
1. The screw holes and the
scale are on the same side
cross
Lock cylinder
screwdriver * 1
extension * 1
TouchEBL61
4
wrench *1
screw *1
Screwdriver
TIGHTEN
2. Turn the wrench counter- 3. Turn the steel piece, insert it into
-clockwise to tighten the interface, align the screw holes,
and tighten the screws with a
Phillips screwdriver.
17mm
30-70mm
Rear handle
.
3.The lock cylinder is installed into the lock hole from the door outside / inside
Screwdriver
4. Installation fixing screw
REMOVE
Restart Diagram
1.Opening the silicone cover
3.Find the hole where the restart button is located
4.Insert the thimble into the hole and press the restart button
5.Just for re-selecting the language settings.
Lock cylinder
extension
, t
SHORTEN LENGTHEN
2.Take out the screw and take out the
front handle/ rear handle according
to your door installation direction.
or
5.Fixed front/rear handle screw
Restart key
2.Find the Thimble in the attached accessories