Ortur Laser Master 3 Manual

Airframe Parts

Laser Module

Assemble the Machine

1. You need the following parts ready
   
   
2. You need the following parts ready
   
   
3. You need the following parts ready
   
   
   
   
4. You need the following parts ready
   
5. You need the following parts ready
   

Connect Wire

Port Description

1. WIFI Aerial
2. Power Input
3. USB Port
4. Main Power Button (Status Light)
5. Key Switch
6. Emergency Stop Button
7. TF-card
8. Upgrade Button (for Upgrading Firmware)
9. Reset Button
10. Input and Output Ports
11. Harness Interface
12. Y-axis Motor Interface
13. YRR Transfer Switch
14. YRR Motor Wire Port

Adjustment of rollers and timing belts

Safety Guidelines

1. The laser engraver could generate laser light. It is strictly forbidden to place any living body under the laser emission port (this port is marked with a yellow warning sign).
2. Patients with photosensitive epilepsy are prohibited from using or approaching the laser device.
3. When using the laser engraving machine, the operator and anyone near the machine must wear laser safety glasses. Do not operate the laser without glasses protection (laser goggles). Our machines come with a pair of safety goggles, but additional laser safety glasses can be purchased commercially. Requirements for goggles: wavelength protection 400-445nm (+-5nm), outer diameter +5, minimum L-level L5.
4. When the laser engraver is working, the operator must pay close attention and not place it alone to prevent the engraved material from catching fire. Please set up the laser engraver in a fireproof area and ensure good ventilation. If possible, we recommend that you purchase a fire extinguisher and keep it close to the machine.
5. Using the laser engraver in a room that can be closed by a door, making sure that neither the laser beam nor stray light can penetrate the window.
6. When using the laser engraver, put the door sign or the warning light on the door to indicate that the laser engraver is running.
7. Make sure there is no flammable material near the laser engraver, we recommend put a fireproof mat under the machine.
8. Ensure adequate environment when operating the laser engraving. Engraving certain materials may generate fumes, which should be exhausted by a dedicated filtered exhaust.
9. When the machine is running, do not touch the laser beam or touch it with other objects, which may cause serious bodily injury or beam reflection. Do not touch the radiator, you may burn your body and hands when the laser engraver just stops working.
10. Do not let children or teenagers use the laser engraver alone (especially children under the age of 14), adult supervision is required at all times.
11. For commercial use, using and registering with regulatory authorities and professional associations is mandatory.
12. The operating temperature range of the machine is -15℃ ~ 30℃.
13. There would be a high risk of fire, when the laser irradiates the engraved object. If the laser engraver is working, it must be taken care of at all times by the skilled operator, who know how to use a fire extinguisher, so that any unexpected situations could be dealt with in time.

If you are having technical issues with our machine, we have a 24 hours team of customer support that would quickly address the problem. Please visit our ticketing system at https://ortur.tech/support or email us at support@ortur.tech
There is also a QR code for scanning to go to the ticketing system webpage.