Device Parts Front camera Magnetic stripe reader Rear I/O connector USB connector Thermal printer Power button NFC tagging area Scan button Scanner Touch Screen IC card reader Speaker Battery cover...
Product Standard Accessories Battery Replacement Insert Battery • P10 (with Battery pack) 1. Slide the battery cover down to open. • Power adapter 2. Plug the battery cable into the port. 3. Place the battery into the battery slot. • USB type C cable 4.
Paper Roll Installation Install SD / SAM Card Paper roll (Thermal paper) recommendation 1. Open the battery cover and take off the battery to reveal the card slots. Width 58mm Diameter 40mm Install a paper roll 1. Pull the both sides of the printer cover to open. 2.
Turn on 1. Plug the USB type C cable to the power adapter. Press and hold the power button on the left side of the P10 until the 2. Connect the cable to the USB connector of the P10. screen is turned on.
Payment Scan a Barcode Scanner is equipped on the top of the P10. Magnetic card Center the cross-hair aimer or red dot aimer over the barcode. You Swipe the card at a proper and can tilt the aimer slightly for a comfortable angle to scan.
Need help?
Do you have a question about the P10 and is the answer not in the manual?
Questions and answers