Jesco DL-FLEX2-NPXCC-HE Quick Start Manual

DL-FLEX2-NPXCC-HE
LOW VOLTAGE FLEXIBLE LINEAR • CONSTANT CURRENT • HIGH EFFICACY
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING - RISK OF FIRE AND ELECTRICAL SHOCK. FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN ONLY. FIXTURE IS
INTENDED FOR INSTALLATION IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, LOCAL AND FEDERAL SPECIFICATIONS.
DISCONNECT POWER AT ELECTRICAL PANEL BEFORE SERVICING. RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
All electrical connections must be in accordance with local codes, ordinances and the National Electric Code. This product operates
on 24V DC; always confirm the maximum wattage of the linear strip does not exceed the maximum wattage of the circuit it is connected
to. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician.
• Do not cover this product as the covering may cause
the flexible light to overheat and melt or ignite.
• Do not operate with the flexible light while attached to
plastic spool or tightly coiled. Excess heat may melt the
spool and/or strip light.
• Do not puncture, cut, shorten, or splice the flexible lighting.
• Do not route the cord or flexible lighting cable through walls,
doors, windows or any like part of the building structure.
• Do not use if there is any damage to the light or cord
insulation. Inspect periodically.
• Do not submerge flexible light in liquids, or use the product
in the vicinity of standing water or other liquids.
1.
Configure design and layout of the system before attempting
to install this product. Do not exceed the maximum operating
temperature of 122 degrees Fahrenheit. For dry or damp
location use only.
DL-FLEX-NPXCC-HE-1W:
DL-FLEX-NPXCC-HE-2W:
DL-FLEX-NPXCC-HE-3W:
DL-FLEX-NPXCC-HE-4W:
DL-FLEX-NPXCC-HE-5W:
SAVE THESE INSTRUCTIONS
ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY, ACTUAL PRODUCT MAY VARY
NY
15 Harbor Park Drive
Port Washington, NY 11050
© 2025 JESCO LIGHTING GROUP, LLC
WARNING: RISK OF FIRE AND SHOCK
RATED 24 VOLT DC | 1.10 Watt/Foot |
| MAX 62 Feet |
RATED 24 VOLT DC | 2.20 Watt/Foot |
| MAX 35 Feet |
RATED 24 VOLT DC | 3.30 Watt/Foot |
| MAX 30 Feet |
RATED 24 VOLT DC | 4.40 Watt/Foot |
| MAX 20 Feet |
RATED 24 VOLT DC | 5.50 Watt/Foot |
| MAX 16 Feet |
CA
Main 800 527 7796
Fax 855 265 5768
• Do not install near areas with exposure to salt water or
chlorinated water.
• Secure this flexible light using only hangers or clips provided.
Do not secure this product with staples, nails, or like means
that may damage the insulation or permanently attach to the
building structure.
• Do not subject flexible lighting to continuous flexing.
• Do not install in environment where LED chips are exposed to
direct sunlight as damage to the phosphor will occur.
• DO NOT EXCEED THE MAXIMUM NUMBER OF EXTENSIONS OR
FLEXIBLE LIGHT LENGTHS PERMITTED BY THE MARKING.
NOTE: For dimming applications refer to the spec sheet
and the wiring diagrams in the following pages
2.
TURN OFF ELECTRICITY
Before beginning installation, switch circuit breaker off or
remove fuse.
3.
Determine location to install components.
219 South 6th Ave
Main
City of Industry, CA 91746
Fax
Installation sheet subject to change without notice
800 527 7796 support@jescolighting.com
855 265 5768 Tech Support 855 592 0029
REV. 01/09/2025