Water sampling station for private swimming pool applications (44 pages)
Summary of Contents for Jesco DL-FLEX2-TILE
Page 1
INSTALLATION INSTRUCTIONS DL-FLEX2-TILE IMPORTANT SAFETY INSTRUCTIONS Please read carefully before using product. Protect yourself and others by observing all safety information, warnings and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property.
INSTALLATION INSTRUCTIONS DL-FLEX2-TILE INSTALLATION 1. Configure design and layout of the system before attempting to install this product. Do not exceed the maximum ambient temperature of 113 degrees F. For dry location use only. Note – For dimming applications refer to the spec sheet and the wiring diagrams below.
Page 3
INSTALLATION INSTRUCTIONS DL-FLEX2-TILE OPTION 2: Using Screws All penetration through FLEXTILE must be made at the designated points marked by the circles on the sheet. Note – Recommended to use pan head, domed or round head screws. Do not fasten screws so much that it deforms the LED Sheet 6.
INSTALLATION INSTRUCTIONS DL-FLEX2-TILE WIRING DIAGRAMS NOTE: Vertical mounting recommended for LED drivers NOTE: Leave at least 1” spacing between LED drivers to allow for airflow to prevent heat buildup NOTE: Leave the power connector with enough slack to account for expansion and contraction due to tempearature changes...
Page 6
INSTALLATION INSTRUCTIONS DL-FLEX2-TILE DIMMING OPTION – 0-10V Plug and Play with PWM output (Using our LC-DIM-5A Dimming Module), with adapter DIMMING OPTION – PWM (Using LC-RF-400-RCV receivers and Radio Frequency controllers). Instruction sheet subject to change without prior notice Rev 59 www.jescolighting.com...