Notes On Batteries - Nikon F55 - F55 35mm SLR Camera Instruction Manual

Notes on Batteries

WARNING
Do not leave
• Use two CR2-type 3V lithium batteries
Use two CR2-type 3V lithium batteries.
• Change the batteries well before the end of their life and prepare spare batteries
before important photographic occasions.
• Turn the camera power off when changing batteries
Turn the camera power off before changing batteries and insert the batteries with
and ends positioned correctly.
• Stains on the battery poles may cause lack of contact. Wipe the batteries well with a
dry cloth before installing.
• Use fresh batteries at low temperatures
Battery power diminishes at extremely low temperatures and the camera may not
function properly with old batteries. Use a fresh set of batteries at low temperatures,
keep spare batteries warm, and use them alternately.
• Film advance speed lowers and number of usable film rolls becomes less at low
temperatures. However, battery power may recover when the temperature returns to
normal.
• Do not throw batteries into a fire or short circuit batteries
Do not throw batteries into a fire. Do not short, disassemble, heat or charge batteries.
102
Keep batteries out of children's reach.
If someone accidentally swallows batteries,
call a doctor immediately.
Troubleshooting
LCD panel Viewfinder
blinks blinks • CPU Nikkor lens other
than G-type is not set to
its minimum aperture.
appears — • Batteries are nearing
exhaustion.
• Batteries are just about
blinks —
exhausted.
• Batteries are exhausted
, and —
frame counter during film rewind.
blink
blinks blinks • Non-CPU lens is
attached or lens is not
attached.
• Film is not correctly
appears —
installed.
and blink blinks • Film is not correctly
advanced.
• Film remains in the
blinks when —
exposure meter camera after film rewind
is complete.
is turned on
Cause Remedy
• Set lens to minimum
aperture.
• Have fresh ones ready.
• Turn the power off and
replace batteries with
new ones.
• Turn the power off,
replace batteries with
new ones and turn the
power on again, then
press two film
rewind buttons
simultaneously for more
than 1 sec. to start film
rewind again. If this
warning appears
frequently, contact
authorised Nikon dealer
or service centre.
• Attach CPU lens. With a
non-CPU lens, set the
exposure mode to M
and set the aperture
with lens' aperture ring.
• Reload film.
• Reload film.
• Remove the film
cartridge.
Page
19
17
17
72
19,
89,
90
20
20
33
103