Mount Lens - Nikon F55 - F55 35mm SLR Camera Instruction Manual

2

Mount Lens

Turn the power switch off and mount the lens to the camera body.
CPU contacts of CPU
G-type Nikkor lens
Nikkor lens
1 Check the lens type.
G-type Nikkor lens, without aperture ring
CPU Nikkor lenses other than G-type (Illustration is D-type Nikkor lens), with
aperture ring
G-type Nikkor lens
The G-type Nikkor lens has no aperture ring; aperture should be selected from
camera body. Unlike other CPU Nikkor lenses, aperture does not need to be set to
minimum.
Check points
• Use a G- or D-type AF Nikkor lens to utilise all of this camera's functions. However,
autofocus cannot be used with AF-S and AF-I lenses, and the Vibration Reduction
function of the VR lens does not function (p. 88).
• Make sure to turn the power switch off when attaching/detaching the lens.
• Avoid direct sunlight when attaching/detaching the lens.
NOTE: Non-CPU Nikkor lens
When a non-CPU Nikkor lens is attached and the power switch is turned on,
blinks in the LCD panel and viewfinder, and the shutter cannot be released
(except in Manual exposure mode). See page 90 for a non-CPU lens.
18
2
CPU Nikkor lens other
than G-type
3
When camera is left unattended without lens
When you leave the camera unattended without a lens attached, be sure to attach
the supplied body cap (page 2), or optional body cap BF-1A. (BF-1 body cap cannot
be used.)
Turn the power switch off and mount the lens to the camera
body.
With G-type Nikkor lens
Position lens in the camera's bayonet mount so that the mounting indexes on lens
and camera body are aligned, then twist lens anticlockwise until it locks into
place. (Be sure not to touch the lens release button.)
With CPU Nikkor lens with aperture ring (other than G-type)
Position lens in the camera's bayonet mount so that the mounting indexes on lens
and camera body are aligned, then twist lens anticlockwise until it locks into
place. (Be sure not to touch the lens release button.) And then, set the lens
aperture to its minimum and lock.
• When the lens is not set to its minimum aperture setting and the power switch is
turned on, blinks in the LCD panel and viewfinder and the shutter cannot be
released.
Detach the lens.
• Push and hold the lens release button, then
turn the lens clockwise to detach the lens.
19