Page 1
Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 11 559 100...
Description of the functions ..................14 Before using for the first time..................15 Selecting extraction mode or recirculation mode............15 Setting up Miele@home ....................15 Performing Scan & Connect ................... 16 Signing out of Wi-Fi (reset to factory settings) ............ 16 Setting up Con@ctivity ....................
Page 3
Contents NoSmell active charcoal filter..................30 Resetting the charcoal filter operating hours counter......... 30 Disposing of charcoal filters..................30 Reactivatable charcoal filter ..................30 Installation........................31 Before installation ......................31 Assembly parts ....................... 31 Appliance dimensions....................32 Safety distance (S) ......................33 Installation recommendations..................
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. The rangehood cannot be used to ventilate the room in which it is ...
Page 5
Installation must be performed by a suitably qualified and competent person. Maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs ...
Page 6
The protective measures provided in the installation and in this Miele product must also be assured in their function and operation in isolated operation or in non-mains synchronous operation, or replaced with equivalent measures in the installation.
Page 7
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Danger of toxic fumes! Great care should be taken when using the rangehood in the same room or the same area of the house as another heating appliance that depends on the air from the room.
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by a heating appliance from being drawn back into the room, when the rangehood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Warning and Safety instructions Overheated oil and fat can ignite, causing fire damage to the rangehood. When cooking with oil or fat, chip pans and deep fat fryers etc., do not leave the pans unattended. Similarly, never leave an open grill unattended when grilling.
Page 10
Accessories and spare parts Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability.
Please retain and dispose of Please dispose of it at your local EPS packaging responsibly. For further community waste collection / recycling information, please contact Miele. centre for electrical and electronic appliances. You are also responsible for deleting any personal data that may be stored on the appliance prior to disposal.
Page 13
Guide to the rangehood a Telescopic extension piece b Tower c Motorised height-adjustable canopy d Control panel e Grease filter f Spacer frame The spacer frame creates a shadow gap between the tower and the ceiling. The rangehood can be installed with or without the spacer frame. g Recirculation grilles Only for recirculation mode DA 4208V D only...
Description of the functions Depending on the model of the Recirculation mode rangehood, the following options are (Applies to the DA 4208V only. A available: conversion kit and charcoal filter are required, which are available as optional Air extraction mode accessories, see “Technical Data”) The air is drawn in and cleaned by the The air is drawn in and cleaned first by...
Switch off the fan and the lighting. App. Press the control and the operating If your Miele cooktop is connected to a hours control at the same time. home Wi-Fi network, you can control the rangehood automatically via the The charcoal filter symbol ...
App, you will be taken to the Apple App ® Store or the Google Play Store™. Install the Miele App and set up a Press and hold the control. user account. Scan the QR code again.
Setting up Con@ctivity network (Con@ctivity 3.0) Con@ctivity is the direct communication system between an Prerequisites: electric Miele cooktop and a Miele - Home Wi-Fi network rangehood. It enables the rangehood to - Wi-Fi enabled Miele cooktop operate automatically depending on the operational state of a Miele cooktop ...
Page 18
Before using for the first time Start the Wi-Fi connection on the cooktop. For further details, see the cooktop operating instructions. When successfully connected 2 and 3 will light up constantly. Quit connection mode on the rangehood by pressing the run-on control .
Operation (automatic mode) Reaction time When Con@ctivity is active, the rangehood always operates in The rangehood reacts with a slight delay automatic mode (see “Before using for because altering the power level on the the first time – Setting up cooktop does not immediately result in Con@ctivity”).
Operation (automatic mode) - if the rangehood has not been used Switching off for approx. 5 minutes after selecting a Switch off all cooking zones. power level manually, or The rangehood fan will reduce its power - if the manually selected power level level in stages over the next few corresponds to the automatic one minutes and will then switch itself off.
Operation (manual mode) It also reduces the risk of residues Cooking without Con@ctivity accumulating in the rangehood and any (manual mode) resultant odours. The rangehood can be operated The run-on function allows the fan to manually if: continue to run for a pre-determined - the Con@ctivity function is not time before switching itself off activated.
Operation (manual mode) Activating/deactivating Power Dimming/switching the management cooktop lighting on/off Switch off the fan and the lighting. The cooktop lighting can be switched on Press the run-on control for and off and dimmed independently of the fan. approx.
Operation (automatic and manual modes) Switch off the fan and the lighting. Operating hours counter Press the control and the The rangehood registers the length of operating hours control at the time it has been operated. same time.
Operation (automatic and manual modes) Altering or deactivating the charcoal Reading the filter operating hours filter operating hours counter counter The charcoal filter is needed for You can check the percentage of time recirculation mode. set already used before the filters need replacing.
Operation (automatic and manual modes) Adjusting the height of the canopy The height adjustment feature on the canopy can be used to - adapt the height of the rangehood to suit the installation conditions. - adjust the working area underneath the rangehood to the height of the user.
Energy saving tips This rangehood operates very efficiently - Use the Con@ctivity function. The and economically. The following will rangehood will switch on and off help you to save even more energy automatically. The rangehood will when using it: select the optimum power level for the cooking you are doing, which - Ensure that there is sufficient ensures low energy consumption.
Unsuitable cleaning agents can becoming dirty again, we recommend damage the surfaces and control treating them with a stainless steel care elements. product (available from Miele). Do not use any cleaning agents Important for appliances with containing soda, acid, chloride, or lacquered casing solvent.
Cleaning and care Removing the grease filter Grease filters When handling the grease filter, Fire hazard! be careful not to drop it. Oversaturated grease filters are a fire This can result in damage to the filter hazard. and the cooktop below. Clean the grease filters at regular Make sure you hold the filter securely intervals.
If you notice any damage, replace the refitting them. grease filters. When removing the filters for You can obtain grease filters from Miele cleaning, also clean off any residues customer service (see end of these of oil or fat from the now accessible...
Refit the grease filters. Charcoal filters are available to order via the Miele online shop (see end of this When to change the NoSmell active booklet for contact details) or directly charcoal filter from Miele.
*INSTALLATION* Installation Before installation Before installation, it is important to read the information given on the 4 extension piece holders following pages as well as the for aligning and securing the telescopic “Warning and Safety instructions” at extension piece the beginning of this booklet.
*INSTALLATION* Installation Appliance dimensions a Installation area: cut-out for feeding through the exhaust ducting, the mains cable and with ...EXT models, the connection cable to the external motor. In recirculation mode, only the mains cable is required. b Alternative installation with spacer frame c Ventilation grille positioned at the top for recirculation d A mains connection cable is required to connect the rangehood to the electricity supply.
*INSTALLATION* Installation Safety distance (S) The minimum distances between the cooking surface of a cooktop (pan support(s) for gas models) and the bottom of the rangehood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance.
*INSTALLATION* Installation Installation recommendations Protective foil - When deciding on the safety distance The housing components have between the cooktop and rangehood, protective foil around them to prevent please note that a distance of them from transport damage. 650 mm above electric cooktops may ...
Page 35
*INSTALLATION* Installation With air extraction mode: - Place a section of the exhaust ducting in the ceiling and feed it down through the cross-sectional area as illustrated. Exhaust ducting of approx. 200 mm in length is required between the ceiling and the rangehood exhaust socket.
Page 36
*INSTALLATION* Installation Use a knife to release the four spacers and the two covers from the spacer frame supplied. Drill four holes 10 mm, approx. 115 mm deep for the plugs supplied. Place the four plugs in the holes and ...
Page 37
*INSTALLATION* Installation Loosen the two telescopic piece clamps from the installation frame. The rangehood is prepared for extraction mode. For recirculation mode (UL), install the directional unit from conversion kit DUI 32 (optional accessory, DA 4208V only) and turn the telescopic extension piece: ...
Page 38
*INSTALLATION* Installation Loosen the screws from the exhaust Place the directional unit in the socket and the hose inside and installation frame with the arrows remove the exhaust socket. It is not pointing to the sides. required for recirculation mode. ...
Page 39
*INSTALLATION* Installation Secure the hose to the directional unit socket using a hose clip. Check that the hose is held securely. Replace the telescopic piece with the recirculation grilles at the top. Replace and secure the top part of the installation frame.
Page 40
*INSTALLATION* Installation The spacer frame can be installed between the tower and the ceiling. This creates a shadow which gives the illusion of a gap between the ceiling and the tower. This is useful if the ceiling is Mount the spacer frame onto the not level or is uneven.
Page 41
*INSTALLATION* Installation Hang the rangehood on the four screws, making sure the controls are at the front. If using the spacer frame, place the two covers into the fixing holes. Align the installation frame and secure it with the screws. The spacers, which were removed from the spacer frame at the start, can be used to align the rangehood...
Page 42
*INSTALLATION* Installation Remove the safety screw for the tower on the inside of the frame. Place the exhaust ducting onto the exhaust socket. For EXT/EXTA models only: Connect the rangehood and the external motor using the connection cable. ...
Page 43
*INSTALLATION* Installation When the canopy is lowered, the distance to the cooktop must not be less than the minimum safety distance (see “Appliance dimensions”). The height range for the appliance can be extended or limited by repositioning the limit switch. ...
Page 44
*INSTALLATION* Installation Move the canopy to the required height by pressing the button and stop it by pressing the or button. Screw the limit switch back on at the same height as the guide. Hold the tower securely, bend back the retaining tabs and carefully lower the tower.
Page 45
*INSTALLATION* Installation T20 M4x16 Insert the safety screw on the inside. Carefully remove the protective foil from the grease filters. Refit the grease filters. With recirculation mode (UL) rangehoods, insert the charcoal filter.
*INSTALLATION* Installation - If the ducting has flaps, these must be Connection for air extraction opened when the rangehood is Before installation, it is important switched on. to read the information given on the Any constriction of the airflow will following pages as well as the reduce extraction performance and “Appliance dimensions”...
*INSTALLATION* Installation Silencer To achieve even further reductions in noise levels, a special silencer (optional accessory) can be fitted in the ducting system. Air extraction mode The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g.
*INSTALLATION* Installation Electrical connection Installation, repairs, and other work by unqualified persons could be extremely dangerous. The manufacturer cannot be held liable for unauthorised work. All electrical work must only be undertaken by a suitably qualified and competent electrician in strict accordance with current national and local safety and building code regulations.
Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele. You can book a Miele customer service call-out online at www.miele.com.au/ service or www.miele.co.nz/service. Contact information for Miele can be found at the end of this booklet.
Cooktop lighting 4 x 3 W Total rated load 417 W Voltage, frequency AC 230 V, 50 Hz Fuse rating 10 A Weight DA 4208V D 37 kg DA 4248V D 45 kg Wi-Fi module Frequency band 2.400–2.4835 GHz Maximum transmission power < 100 mW Optional accessory for recirculation mode...
Page 51
43rd Floor Unit 4301-4303 Singapore 138565 689 Sukhumvit Road Tel.: +65-67351191 North Klongton Sub-District Fax: +65-67351161 Vadhana District E-mail: info@miele.com.sg Bangkok 10110, Thailand Internet: www.miele.sg Miele Global Headquarters Germany Miele & Cie. KG Carl-Miele-Straße 29, 33332 Gütersloh, Federal Republic of Germany...
Page 52
DA 4208V D, DA 4248V D en-AU, NZ M.-Nr. 11 559 100 / 02...
Need help?
Do you have a question about the DA 4208V D and is the answer not in the manual?
Questions and answers