Honeywell HCCNVE5R3K Quick Installation Manual page 5

Cautions and Warnings
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
WARNING
To ensure compliance with electrical safety standards,Local
Certified / CSA Certified / UL Listed LPS or Class 2 power
adapters are required. Power over Ethernet (PoE) shall be
provided by listed Information Technology Equipment meeting
the IEEE 802.3af PoE standard. The PoE is not intended to be
connected to exposed (outside plant) networks.
Consult Honeywell for the recommended adapter.
CAUTION
Invisible LED radiation (850 nm). Avoid exposure to beam.
Important Safeguards
• Read and keep these instructions.
• Please ensure that your installation area can safely support
the weight of the camera.
• Do not aim the camera toward a bright light source for
extended periods to prevent damage to the imager. Avoid
operating the unit under or close to unstable light sources
(may cause flickering), or close to fluorescent lamps or
objects reflecting light.
• Do not touch the camera lens.
• Do not drop the camera or subject it to physical shock.
• Do not use a strong or abrasive detergent when cleaning
the camera.
• Avoid operating or storing the unit in extremely humid,
dusty, hot/cold environments, where the operating
temperature is outside the recommended range of -22°F
to 131°F (-30°C to 55°C).
• Avoid operating the unit close to sources of powerful
electromagnetic radiation, such as radio or TV transmitters.
• The product is only to be connected to PoE network without
routing to outside plant.
• If powered by a power adapter, the adapter should be
properly grounded. (Consult Honeywell for the
recommended adapter).
• Installation and dismantling should be performed only by
qualified and experienced technicians.
• Make sure the power is cut off before the product is being
repaired or installed.
• The product can be ceiling or wall mounted. When wall
mounted, the Cable Gland will face down and make sure the
height of the product is above 3 meters.
• Please contact the authorized distributor of Honeywell for
THIS SYMBOL INDICATES THAT
DANGEROUS VOLTAGE
related accessories (Cable Gland, Cable, etc.) for purchase
CONSTITUTING A RISK OF
and installation.
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.
• The camera should be installed at least 10 centimeters away
from the eave of a building.
• If a Class I adapter or switch is used to provided power, be
THIS SYMBOL INDICATES THAT
IMPORTANT OPERATING AND sure that the power cord is firmly plugged into the socket
MAINTENANCE INSTRUCTIONS
and confirm the main earth connection.
ACCOMPANY THIS UNIT.
Regulatory Statements
FCC Statement of Compliance
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment. This Class A digital apparatus complies
with Canadian ICES-003.
Manufacturer's Declaration of Conformance
Europe
The manufacturer declares that the equipment supplied
with this guide is compliant with the European Parliament
and Council Directive on the Restrictions of the use of certain
hazardous substances in electrical and electronic equipment
(2011/65/EU) as Amended by RoHS 3 (2015/863), and the
essential requirements of the EMC Directive (2014/30/EU),
conforming to the requirements of standards EN 55032 for
emissions, EN 50130-4 for immunity, and EN 62368-1 for
electrical equipment safety.
Waste Electrical and Electronic Equipment (WEEE)
Correct Disposal of this Product (applicable in
the European Union and other European countries
with separate collection systems).
This product should be disposed of, at the end of
its useful life, as per applicable local laws,
regulations, and procedures.
Check Local Waste Guidelines
Components of this product require separate waste collection.
Check local waste guidelines for sorting rules.
Covered by one or more claims of the patents listed at patentlist.
hevcadvance.com
Please be aware that this product can store personal data.
Personal data is protected by the General Data Protection
Regulation (2016/679) in Europe and therefore the owners
of personal data have obtained certain rights thanks
to this regulation.
We strongly advise you to be fully aware of these owner
("data subjects") rights as well as which limitations you have
to obey regarding the use and distribution of this data.
Further details can be found on the GDPR website of the EU
buildings.honeywell.com/security
+1 800 323 4576 (North America only)
Document 800-35QI02 Rev B-10/2024
© 2024 Honeywell International Inc. All rights reserved. No part of this publication may be
reproduced by any means without written permission from Honeywell. The information in this
publication is believed to be accurate in all respects. However, Honeywell cannot assume
responsibility for any consequences resulting from the use thereof. The information contained
herein is subject to change without notice. Revisions or new editions to this publication may be
issued to incorporate such changes. For patent information, see https://buildings.honeywell.
com/en-us/company/patent.
.