Compaq DL760 - ProLiant - 1 GB RAM Upgrade Manual page 3

2. Remove the processor and memory module from the
chassis by pressing in the module stop latches (1) and
pulling the module out of the chassis (2). The processor
and memory module will not be reused.
To remove the I/O module:
1. Release the I/O module by pressing in the sides of the
module release levers (1) and rotating the top of the levers
downward (2). Pull the module out of the chassis until it
reaches the module stop latches (3).
2. Remove the I/O module from the chassis by pressing in
the module stop latches (1) and pulling the module out of
the chassis (2). The I/O module will not be reused,
but any I/O expansion boards must be transferred
to the new I/O module.
To remove the server midplane, disengage the power supplies
and the media module. To remove the power supplies:
1. Squeeze upward on the release in the middle of the power
supply 1 handle (1).
2. Rotate the power supply handle downward (2) and slide
forward (3). Ensure power supply 1 is disengaged from
the midplane.
3. Repeat steps 1 and 2 for power supply 2.
To release the media module:
1. Press in the sides of the cam levers on the media module
(1) and rotate the tops of the levers downward (2).
2. Pull the media module out of the chassis until the module
makes contact with the module stop latches (3).
Continued on next page