Plikc NEVE PRO RF User And Installation Manual page 11

Weekly Mode Programming
You can choose from 3 types of weekly programming modes:
- 5+2: Two groups of days with a unique and individual schedule for each group:
• 1st Group: Monday to Friday (LUN - VEN).
• 2nd Group: Saturday and Sunday (SAB - DOM).
- 7 Days: A single group of days from Monday to Sunday (LUN - DOM) with a unique program.
- 24 Hours: The ability to program each day of the week separately and differently.
Note: The factory settings of the thermostat are set to the 5+2 weekly programming mode, as indi-
cated in the following table:
20
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
Note: If you do not need all 8 daily phases, you can exclude them as follows:
1. Once you have selected the phase to exclude, press the ON/OFF/OROLOGIO button.
2. Instead of the time, the display will show "- - - -".
3. Press SET to confirm.
4. Repeat the same procedure for all phases you wish to exclude.
Keep in mind that if the excluded phase was in the middle (for example, phase 5), the subsequent
phases will shift backward, so phase 6 will become phase 5.
If you do not need all 8 daily phases, you can exclude them in this way: once you have
selected the phase to be excluded, press the "clock/power" button. Instead of the time, the
display will show "- - - -" then press the "SET" button to confirm. Repeat the same procedu-
re for all the phases to be excluded, taking into account that if the deleted daily phase was
intermediate, for example 5, the subsequent ones will be moved backwards, therefore 6 will
become 5.
Note: Another way to neutralize the daily phases that are not needed is to set them to a
temperature low enough to prevent any activation. For example, setting them to 10°C.
Plikc S.r.l. - Via del Lago Terrione, 83 - 00165 Roma - info@plikc.com - www.plikc.com
21