Vc Support For Flex-10; Recommended Firmware; Vc Flexnic Support - Compaq BL10e - HP ProLiant - 512 MB RAM Introduction Manual

Hp flex-10 technology

Hide thumbs Also See for BL10e - HP ProLiant - 512 MB RAM:

Table of Contents

Figure 9. HP SFP+ module with copper cabling

The SFP+ with copper cabling can be used with the SFP+ ports on the Flex-10 Enet module and is

thinner than CX4 cabling. This cable configuration is ideal for stacking modules within an enclosure.

Fiber Optic uplink cables can be sourced from third-party vendors who meet industry-standard

specifications for Ethernet cable types. Cable distances are best case based on fiber core

specifications.

For listings of all Flex-10 compliant cables, connectors, and transceiver modules, please see Table A2

in the appendix.

VC support for Flex-10

The goal of VC support is to extend to Flex-10 and FlexNICs the full range of services and

management capabilities associated with server NIC operation.

For optimal operation of HP Virtual Connect Manager (VCM) with Flex-10, administrators should

install the recommended firmware versions of the VCM, OA, and iLO firmware. The latest information

on firmware compatibility can be found at

http://h18004.www1.hp.com/products/blades/components/vc-

compmatrix.html

VC is able to set the FlexNIC MAC address and transmit bandwidth and assign each FlexNIC to a

Virtual Connect network (vNet). When a Flex-10 NIC device is connected to an HP VC Flex-10

Ethernet Module (interconnect), it will enumerate four FlexNICs per port (eight total FlexNICs).

Table of Contents

Do you have a question about the BL10e - HP ProLiant - 512 MB RAM and is the answer not in the manual?