Computer Setup-Security - HP 6000 - ProLiant - 128 MB RAM Setup Utility Manual

Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 4 Computer Setup—Security
Option
Setup Password
Power-On Password
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Device Security
USB Security
Slot Security
6 Computer Setup (F10) Utility
Description
Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
See the Desktop Management Guide for more information.
Allows you to set and enable a power-on password. The power-on password prompt appears after
a power cycle. If the user does not enter the correct power-on password, the unit will not boot.
NOTE: This password does not appear on warm boots , such as
Windows, unless enabled in Password Options (see below).
See the Desktop Management Guide for more information.
Allows you to:
●
Lock legacy resources (appears if a setup password is set)
●
Enable/disable network server mode (appears if a power-on password is set)
●
Specify whether the password is required for warm boot (Ctrl+Alt+Delete) (appears if a power-
on password is set)
● Enable/Disable Setup Browse Mode (appears if a setup password is set) (allows viewing, but
not changing, the F10 Setup Options without entering setup password)
●
Enable/disable Stringent Password (appears if a power-on password is set), which when
enabled bypasses the onboard password jumper to disable the power-on password.
See the Desktop Management Guide for more information.
Allows you to set Device Available/Device Hidden for:
●
Serial ports
●
Parallel port
● System audio
●
Network controllers (some models)
● Embedded security device (some models)
●
SATA0
● SATA1
●
SATA2
● SATA3
Allows you to disable individual or groups of USB ports.
Allows you to disable PCIe and PCI slots along with cards plugged into them.
Ctrl+Alt+Delete or Restart from
ENWW