Page 1
INSTRUCTION MANUAL RWROM36-48V RIDE-ON ELECTRIC LAWNMOWER READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in...
RWROM36-48V Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols: You WILL be KILLED or...
Page 3
RWROM36-48V General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must have • The equipment must be serviced or cords, power bars, and electrical fittings for an approved cord and plug and be repaired at authorised service centres by damage or wear before each use.
Page 4
RWROM36-48V • Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second. Machine Use and Care • Do not force the machine. Use the correct machine for your application. The correct machine will do the job better and safer at the rate for which it was designed.
Page 5
RWROM36-48V Preparation • Wear heavy, long trousers, long sleeves, and sturdy anti-slip footwear. Do not wear short trousers, sandals, or go barefoot. Avoid wearing clothing that is loose fitting or that has hanging cords or ties. • Always wear safety glasses with side shields. Use a face mask if operation is dusty. Objects struck by the blade can cause severe injuries to persons.
RWROM36-48V • WARNING: RISK OF FIRE, EXPLOSION, OR BURNS. DO NOT DISASSEMBLE, EXPOSE TO HEAT ABOVE 60°C, OR INCINERATE THE BATTERY PACK. • The battery pack contains acid. If acid comes in contact with skin or clothing, flush immediately with water for 10 minutes. If liquid comes in contact with eyes, seek medical help immediately.
Page 7
RWROM36-48V • replace the blade if it is damaged in any way • repair any damage before restarting and continuing to operate the product. • whenever the product starts to vibrate abnormally (check immediately) • inspect for damage, particularly the blades •...
RWROM36-48V Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc., replace them. Flying Debris Hazard Flammable Material Hazard Read User Manual...
RWROM36-48V Table of Contents Safety ..............................2 Safety Symbols ..............................8 Table of Contents ............................9 Assembly ..............................11 Unpacking ................................11 Loose Parts List ..............................13 Connecting the Battery ............................14 Installing the Seat ..............................15 Installing the Steering Column ..........................16 Charging the Product .............................
RWROM36-48V Assembly WARNING: Strictly adhere to all torque wrench tightening specifications. Failure to do so could cause serious personal injury. All information, illustrations, photographs, and specifications contained in this manual are based on the latest product information available at the time of publication.
RWROM36-48V Loose Parts List WARNING: If any parts are damaged or missing do not assemble the product until the parts are replaced with new original manufacturer’s parts. Assembling the product with damaged, missing, or incorrect parts could result in serious personal injury.
RWROM36-48V Installing the Seat 1. Remove the bolts and flange nuts from seat mounting brackets. 2. Place the seat assembly over the mounting brackets, aligning the holes as shown. 3. Reinstall and securely tighten the bolts and flange nuts. 4. Route the seat safety interlock cable through hole in the wiring cover, then connect to the plug on the mower.
RWROM36-48V Installing the Steering Column 1. Put the shaft into the lower steering rod to align the shaft and lower steering rod mounting holes. After inserting the bolts, tighten them with Flange nut. The recommended torque is 25±2N.m. 2. After installing the shaft, put the decorative tube on the shaft, 3.
RWROM36-48V Charging the Product Lift cover & connect plug then connect charger to power socket After connecting the charger these red lights will be on to indicate that the mower is charging normally. Mower batteries must be charged overnight before first use. To verify mower batteries are fully charged, check the battery level indicator.
RWROM36-48V 5. When you are ready to mow, disconnect the charger from the power supply, then disconnect the charger from the mower. 6. If the machine is stored unused for a long time, in order to prolong the service life of the battery, it is recommended to charge it once every three months.
Page 20
RWROM36-48V No. Name Function & Purpose Seat Adjustment Lever Rotate the seat adjustment lever to adjust the front and rear position of the seat. Reverse Pedal The back pedal controls the back movement and speed of the ride-on mower. Accelerator Pedal The forward pedal controls the forward movement and speed of the ride-on mower.
RWROM36-48V Pre-Operation Checks • Remove any objects in the work area that may be knocked up or entangled by the blade. • Check whether the brake is normal. • Check tyre pressure. • Check if the fasteners are loose. •...
RWROM36-48V Installing the Mulch cover The mower is configured for side discharge when shipped. If mulching is desired: 1. Lift the stud and then raise the side discharge chute. 2. Place the mulch cover on the tab on the mower housing.
RWROM36-48V Engaging the Parking Brake 1. Fully depress and hold the brake pedal and depress the parking brake at the same time, or firstly depress the parking brake, then fully depress the brake pedal. 2. Release the brake pedal. 3. Release the parking pedal.
RWROM36-48V Adjusting the Seat Before operating the ride-on mower, adjust the seat position to ensure that your feet can push in the accelerator pedal and brake pedal firmly. To move the seat: 1. Turn key to OFF position and set the parking brake.
Need help?
Do you have a question about the RWROM36-48V and is the answer not in the manual?
Questions and answers