1 Important General information safety To avoid damage or malfunction: instructions Caution • Do not expose headphones to excessive heat. • Do not drop your headphones. • Headphones shall not be exposed to dripping Hearing safety or splashing. (Refer to the IP rating of specific product) •...
Page 3
2 Your In- Overview of your In-ear ear wired wired headphones headphones Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support. With these Philips in-ear wired headphones you can: •...
3 Get started 4 Use your headphones How to wear Connect the headphone Check left or right orientation of the to your device headphones. Connect headphone to your device via Insert the headphones into the ears USB-C connector. and twist slightly until a secure fit is achieved.
5 Technical data 6 Notice Disposal of your old Sound product • Frequency response: 20 - 20,000 Hz • Impedance: 32 Ohm • Maximum power input: 5 mW • Sensitivity: 106 dB Your product is designed and • Speaker diameter: 14.2 mm manufactured with high quality materials and components which can be recycled and reused.
Page 6
MMD Hong Kong Holding Limited. All rights reserved. Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
Need help?
Do you have a question about the 1000 Series and is the answer not in the manual?
Questions and answers