Page 1
Please read this manual carefully before operating Please read this manual carefully before operating your dishwasher. Retain it for future reference. your set and retain it for future reference. WM0642H* D1417W(L,M,T,B,C,D)F(B,U) D1418W(L,M,T,B,C,D)F(B,U) D1419W(L,M,T,B,C,D)F(B,U) DW-EN105W / DW-EN105T DW-EN100W www.lg.com P/No. : MFL62077155 P/NO : MFL31245123...
ONTENTS SAFETY AND CAUTION INSTALLATION INSTRUCTIONS PARTS NAME FUNCTION OF CONTROL BUTTON BEFORE USING FOR THE FIRST TIME INFORMATION FOR ENERGY TEST HOW TO USE AND OPERATE OPERATING SEQUENCE PROGRAM USER MAINTENANCE INSTRUCTIONS TROUBLE SHOOTING GUIDE SPECIFICATION...
AFETY AND CAUTION IMPORTANT SAFETY INSTRUCTIONS WARNING - When using your dishwasher, follow basic precautions, including the following: • Please read this manual carefully before using • If power supply cord is damaged, it must only the dishwasher for the first time. be replaced by the manufacturer or its service •...
Page 4
AFETY AND CAUTION CAUTION Concerning the Power Cord Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain. Do not overload wall outlets.
NSTALLATION INSTRUCTIONS WARNING A qualified electrician/plumber or competent person should carry out any electrical/plumbing work required to install this appliance. Step 1 : Step 2 : PREPARE CUPBOARD OPENING PREPARATION FOR ELECTICAL WIRING CAUTION This dishwasher is designed to fit the size shown as below.
Page 6
NSTALLATION INSTRUCTIONS Step 3 : Step 4 : PREPARING THE DISHWASHER INSTALLING THE FOR INSTALLATION DISHWASHER IN CUPBOARD Lay the dishwasher on its back. Before sliding the dishwasher into the cupboard opening, all necessary height Adjust the legs to the required height and balancing adjustments should be as shown in below figure.
NSTALLATION INSTRUCTIONS Step 5 : When the drain hose is connected to a separate standpipe, it is essential that an DRAIN LINE CONNECTION airtight connection be made. Refer to Fig.B If the end of drain hose does not fit to the drain line, use a rubber connector(not supplied) that is resistant to heat and detergent.
NSTALLATION INSTRUCTIONS Step 6 : Step 8 : CONNECTION OF WATER INLET HOSE HOW TO LEVEL THE DISHWASHER After installing the dishwasher, you may Connect the water supply hose to the water tap. notice a slight sticking of the door to the (Fig.
ARTS NAME 1. Control Panel 11. Upper Rack 2. Door Handle 12. Cutlery Basket 3. Front Cover 13. Detergent And Rinse Aid Dispenser 4. Lower Cover 14. Vapor Vent Cover 5. Display Window 15. Upper Spray Arm 6. Power Button 16.
UNCTION OF CONTROL BUTTON MODEL : D1418W(L,M,T,B,C,D)F(B,U) D1419W(L,M,T,B,C,D)F(B,U) DW-EN105W / DW-EN105T MODEL : D1417W(L,M,T,B,C,D)F(B,U) DW-EN100W...
Page 12
UNCTION OF CONTROL BUTTON Process Indicator • Indicates current program phase. • The Wash, Rinse and Dry lamps twinkle while each phase of washing process. • The Clean lamp turns on after all procedure is ended for 4minutes. Salt & Rinse Refill Indicator •...
EFORE USING FOR THE FIRST TIME Hardness setting You have to check your water hardness and set the softening system level before operating your dishwasher. < Water hardness level > Step 1. Check and find water hardness level Method 1 1) Check the water hardness of your area.
EFORE USING FOR THE FIRST TIME Step 3 . Salt Filling This model has a water softener to soften hard water. Please read these notes carefully for correct operation. In order to provide satisfactory rinsing results, the dishwasher requires soft water, i.e., containing little or no lime, otherwise water stains will be left behind on the dishes and interior containers.
NFORMATION FOR ENERGY TEST (EN50242) 2. Upper Rack Appliance loaded in accordance with standard specifications. • Capacity : 14 place settings • Comparability course : Eco • Rinse Aid setting : 4 • Reference cleaner : 8g of detergent onto the inside surface of the door and fill 27g into the detergent dispenser.
OW TO USE AND OPERATE 1. Cutlery Basket For better washing performance, always load the dishwasher according to the instructions. Place forks and spoon in the cutlery basket with their handles downwards. Before loading items into the dishwasher • Clean off large particles of food, in particular insoluble items such as bones, pips etc.
Page 17
OW TO USE AND OPERATE 2. Lower Rack 3. Upper Rack The lower rack is best loaded with dinner It is best to load this with more delicate items plates, soup bowls, dishes, pots, pans, lids and such as, small plates, long cutlery, cups, even the grill tray.
Page 18
OW TO USE AND OPERATE D1419W(L,M,T,B,C,D)F(B,U) D1417W(L,M,T,B,C,D)F(B,U) DW-EN105W / DW-EN105T D1418W(L,M,T,B,C,D)F(B,U) DW-EN100W Your upper rack can be raised or lowered to cater for different sized crockery. Before Your upper rack can be raised or lowered to adjusting, ensure that the rack is empty.
OW TO USE AND OPERATE 4. Adding Detergent • Detergent must be put into the detergent chamber before starting every program. Push latch to open • Please follow the manufacturer’s instructions within the manual, when determining the correct amount of detergent to use. •...
OW TO USE AND OPERATE 5. Refilling WARNING For refilling Rinse Aid The detergent used is a special Depending on the dosage setting and the Dishwasher detergent and like all number of washes, the chamber may need to household chemicals it should be be topped up, approximately once a month.
Page 21
OW TO USE AND OPERATE 6. Drying For refilling Salt To assist drying, we recommend that the door be partially opened after the cycle. When the salt container is empty, the salt refill The display will indicate "Cd"(cool dry) for lamp will automatically turn on during a further 30 minutes after the end of the operation.
PERATING SEQUENCE After starting, the display window shows Press the “Power” button the remaining time. The time in the display window will start Check there is rinse aid to decrease minute by minute. and salt If the door is opened during the program a safety device ensures that the machine The corresponding indicator lights will stops.
ROGRAM Running time may vary according to the water temperature, water pressure and voltage. Running time doesn’t include “Cool Dry - 30min”. WASH RINSE COOL Program Heating Pre Wash Main Wash Rinse 1 Rinse 2 Rinse 3 Rinse Dual Intensity The program sequence is optimized and adapted in accordance with how dirty the Auto dishes are.
SER MAINTENANCE INSTRUCTIONS To prevent trouble and poor operating, it is important to check filters and spray arms at regular intervals. Filters Upper Spray Arm • Remove the lower rack first. • Pull the upper rack forwards. • Turn the mesh filter counterclockwise. •...
ROUBLE SHOOTING GUIDE If a problem occurs check below to see whether this can be solved. In the unlikely event that the problem cannot be rectified, please contact a service engineer. Problem Possible Causes Solution • Plug is not properly inserted into the socket.
Page 26
ROUBLE SHOOTING GUIDE Problem Possible Causes Solution • Straighten hose(s). • The drain hose is kinked. The display shows "OE" • Clean the filter. • The filter is clogged. code. (Water is not • If you can not solve • Motor trouble. pumped away.) the problem, call for (Washing motor or Drain motor)
Page 27
ROUBLE SHOOTING GUIDE These are not error codes indicating a malfunction. Code Description This indicates there was a power failure. This function protects The display shows the dishwasher in the event the power goes out or the power to “PF” code the unit is disrupted.
Need help?
Do you have a question about the DW-EN105W and is the answer not in the manual?
Questions and answers