CONTENTS Important Safety Instructions Contents: Warnings and safety instructions appearing in this Important Safety Instructions ..........2 guide are not meant to cover all possible conditions and Unpacking Your Appliance ..........3 situations that may occur. Common sense, caution, and Installing Your Appliance ............4 care must be exercised when installing, maintaining, or Installing the Anti-Tip Device ..........6 operating this appliance.
If there is damage, the packaging will be needed as proof of damage in transit. Afterwards please dispose of all items responsibly. VIKING RANGE, LLC GREENWOOD, MS 38930 WARNING XXXXXXXXXXXX...
Viking Range, LLC does not recom- Raise or lower the legs to the required dimension by turning mend the use of a custom made grille as air fl ow may be the legs.
INSTALLING YOUR APPLIANCE WARNING Electrical Shock Hazard Do not remove • Do not use an extension cord with this appliance. ground prong They can be hazardous and can degrade product performance. • This appliance should not, under any circumstanc- es, be installed to an un-grounded electrical supply. •...
INSTALLING THE ANTI-TIP DEVICE Anti-Tip WARNING Bracket Leveling Leg • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP Bottom View of ⁄ " BRACKET PACKED WITH Beverage (54.6 cm) THE APPLIANCE. Center • FOLLOW THE INSTRUC- TIONS BELOW Front of cabinet Anti-Tip Device Figure 7...
Page 7
INSTALLING THE ANTI-TIP DEVICE NOTE When the floor mounted anti-tip bracket is used the mini- mum adjusted height of the cabinet is increased by ⁄ " (9 mm). "V" notches Rear Leveling leg in bracket Figure 8a Screw ⁄ " (54.6 cm) Figure 8 "V"...
DOOR REVERSAL Door Reversing Instructions 1. Open door. 2. Loosen screw #1 and #2 using a Philips Screwdriver on top and bottom hinge. Slide door and remove the door from the unit. Figure 9 3. Once door is removed, using a Philips Screwdriver remove screws from magnet actuator located on inside and bottom of door.
CUTOUT AND PRODUCT DIMENSIONS ROUGH-IN OPENING DIMENSIONS CABINET DIMENSIONS “A” “B” “C” “D” “E” “F” “G” “H” “J” 24” 34” to 35” 24” 23 7/8” 33 3/4” to 34 3/4” 23 5/8” 47 3/4” (61 cm) (86.4 cm to 88.9 cm) (61 cm) (60.7 cm) (85.7 cm to 88.3 cm)
Page 10
CUTOUT AND PRODUCT DIMENSIONS PRODUCT DATA ELECTRICAL PRODUCT REQUITEMENTS # WEIGHT 140 lbs 115V/60Hz/15A (63.6 kg) “H” “D” “F” “E” Glass Door 21 1/2” 3 1/2” (8.9 cm) (54.6 cm) Shown Minimum Figure 14 Minimum rough-in opening is required to be larger than the adjusted height of the cabinet.
INTEGRATED PANEL DIMENSIONS Clearance Clearance for hinge for hinge at top and at top and bottom bottom Figure 15 Figure 16 Left Hand Hinged Door Right Hand Hinged Door 24" (61 cm) wide appliance 24" (61 cm) wide appliance Figure 18 Figure 17 1/4"...
INTEGRATED PANEL INSTALLATION Integrated door panel installation: If you purchased an integrated panel model, your unit is equipped with articulated hinges to allow fully integrated built-in installations. Custom panel thicknesses of ⁄ " (15 mm) and ⁄ " (18 mm) are accommodated. CAUTION It is important to use the factory provided grille that came with the product to assure proper air flow is maintained...
Page 13
INTEGRATED PANEL INSTALLATION WARNING Use extreme caution with the articulated hinges. The hinge is self closing and many pinch points exist prior to built-in installation. Do not remove the cabinet "Z" bracket from the top of the cabinet. Integrated Step 2: Remove the door gasket panel flush With the door laying on a flat surface and starting at a with top and...
Page 14
INTEGRATED PANEL INSTALLATION CAUTION Weight of integrated door panel must not exceed 15 pounds (6.8 kg) for a solid door model or 10 pounds (4.5 kg) for a glass door model. Figure 21a #10 x ⁄ " screw Material Type #10 Wood Screw Hardwood ⁄...
INTEGRATED PANEL INSTALLATION Step 5: Install the door Carefully open the top and bottom hinges on the door being careful as there are many pinch points. Place the hinges over the 4 screws in the cabinet, 2 at the top and 2 at the bottom and slide the door into position.
“HH” will appear in display (High Temp) upon ambient temperature, temperature of product loaded, door • “LL” will appear in display (Low Temp) openings, etc. Viking recommends allowing the unit to reach set points before loading. Contact service dept. for further instructions.
SHELVING CONFIGURATIONS To Add or Remove a Shelf CAUTION Remove stored product from the shelf. Do not try to remove a loaded shelf from the appliance. Grasp the shelf front with both hands, rotate the front upward and lift out. (See Figure Make sure your cantilever shelf is secure on the shelf 26b).
CARE AND CLEANING AND ENERGY SAVING TIPS The following suggestions will minimize the Front Grille cost of operating your refrigeration appliance. Be sure that nothing obstructs the required air fl ow open- ings in front of the cabinet. At least once or twice a year, brush or vacuum lint and dirt from the front grille area (see 1.
Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range, LLC at (888) 845-4641 or write to: VIKING RANGE, LLC...
TROUBLESHOOTING Before You Call for Service CAUTION If the appliance appears to be malfunctioning, read through this manual fi rst. If the problem persists, check the troubleshooting guide below. Locate the problem in the In the unlikely event you lose cooling in your unit, do not guide and refer to the cause and its remedy before calling unplug the product from the electric supply, but do call for service.
Any sealed refrigeration system component, as listed below, is warranted to be free from defective materials or workmanship in normal household use during the third through the sixth year from the date of original retail purchase. Viking Range, LLC, warranter, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.
Page 22
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com 30734 (111124)
Need help?
Do you have a question about the FRUI5242D and is the answer not in the manual?
Questions and answers