Usb Configuration - Asus Vintage User Manual

5.4.6 5.4.6 5.4.6

USB Configuration

USB Configuration USB Configuration
5.4.6 5.4.6 USB Configuration USB Configuration
The items in this menu allows you to change the USB-related features.
Select an item then press <Enter> to display the configuration options.
Onboard SiS USB1.1 Device
Onboard SiS USB2.0 Device
USB Configuration
Module Version - 2.23.2-9.4
USB Devices Enabled: None
Legacy USB Support
USB 2.0 Controller Mode
Stop EHCI HC in OHCI handover [Enabled]
Onboard SiS USB1.1 Device [Enabled] Onboard SiS USB1.1 Device [Enabled] Onboard SiS USB1.1 Device [Enabled] Onboard SiS USB1.1 Device [Enabled] Onboard SiS USB1.1 Device [Enabled]
Enables or disables the onboard SiS USB1.1 device.
Configuration options: [Enabled] [Disabled]
Onboard SiS USB2.0 Device [Enabled] Onboard SiS USB2.0 Device [Enabled]
Onboard SiS USB2.0 Device [Enabled] Onboard SiS USB2.0 Device [Enabled] Onboard SiS USB2.0 Device [Enabled]
Enables or disables the onboard SiS USB2.0 device.
Configuration options: [Enabled] [Disabled]
Legacy USB Support [Auto] Legacy USB Support [Auto] Legacy USB Support [Auto] Legacy USB Support [Auto] Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB devices. Setting to
Auto allows the system to detect the presence of USB devices at startup.
If detected, the USB controller legacy mode is enabled. If no USB device is
detected, the legacy USB support is disabled. Configuration options:
[Disabled] [Enabled] [Auto]
USB 2.0 Controller Mode [HiSpeed] USB 2.0 Controller Mode [HiSpeed] USB 2.0 Controller Mode [HiSpeed]
USB 2.0 Controller Mode [HiSpeed] USB 2.0 Controller Mode [HiSpeed]
Allows you to configure the USB 2.0 controller in HiSpeed (480 Mbps) or
Full Speed (12 Mbps). Configuration options: [HiSpeed ] [FullSpeed]
Stop EHCI HC in OHCI handover [Enabled] Stop EHCI HC in OHCI handover [Enabled] Stop EHCI HC in OHCI handover [Enabled] Stop EHCI HC in OHCI handover [Enabled] Stop EHCI HC in OHCI handover [Enabled]
When set to [Enabled], the BIOS stops the EHCI host controller during OHCI
OS handover call. This is needed for installing operating systems that do
not support EHCI host controllers. Configuration options: [Disabled]
[Enabled]
A S U S V i n t a g e - S 8 0 0 A S U S V i n t a g e - S 8 0 0 A S U S V i n t a g e - S 8 0 0 A S U S V i n t a g e - S 8 0 0 A S U S V i n t a g e - S 8 0 0
[Enabled]
[Enabled]
[Auto]
[FullSpeed]
<Enter> to enable or
disable.
5 - 2 1 5 - 2 1 5 - 2 1 5 - 2 1 5 - 2 1