Table of Contents
Advertisement
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto]
SMART Monitoring [Auto]
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology)
capability of your hard drive. This features allows your system to report read/write
errors of the hard drive and to issue warnings when a third party hardware monitor
utility is installed. Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled]
[Enabled]
5.3.4
Configure SATA as [IDE]
Sets the configuration for the Serial ATA connectors supported by the Southbridge
chip. Configuration options: [IDE] [AHCI]
•
•
5-16
If you want to use the Serial ATA hard disk as Parallel ATA phisical storage
devices, keep thte default setting [IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows the
onboard storage performance on random workloads by allowing the drive to
internally optimize the order of commands.
Chapter 5: BIOS setup
Advertisement
Table of Contents
