Subscribe to Our Youtube Channel
Related Manuals for CORNING Stripettor 4099
Summary of Contents for CORNING Stripettor 4099
- Page 1 Corning Stripettor Ultra ® ® Pipet Controller Instruction Manual Catalog Number: 4099...
- Page 2 H – Membrane filter – PP/PTFE PTFE: Polytetrafluoroethylene J – Connector gasket – SI SI: Silicone K – Battery cover – PP L – Battery – NiMH, AAA, 1.2V Casing – PP M – Wall mount – PP CORNING STRIPETTOR ULTRA PIPET CONTROLLER...
- Page 3 Instruction Manual...
-
Page 4: Table Of Contents
13.0 Equipment Disposal ............. . . 7 CORNING STRIPETTOR ULTRA PIPET CONTROLLER... -
Page 5: Introduction
1.0 Introduction The pipet controller is a device intended for pipetting liquids with the use of measuring pipets. It can work with all types of glass or plastic pipets in the volume range from 0.5 mL to 100 mL. Two dispense modes permit selection of dispensing intensity depending on the user’s needs. The selected setting of the pipet controller mode is shown on the display (Figure 1E). -
Page 6: Switching On
The deeper the button is pressed the faster the liquid is aspirated into the pipet. It is recommended to draw a slightly greater liquid volume than required (due to meniscus above the required volume mark), adjusting the aspiration speed, so as not to overfill the pipet. CORNING STRIPETTOR ULTRA PIPET CONTROLLER... -
Page 7: Troubleshooting
Setting the volume After the pipet is filled, dry the outside surface with absorbent paper that does not leave impurities. Then set the required liquid volume precisely. Pressing the dispense button gently (Figure 3.3), dispense the excessive liquid from the pipet until the meniscus of the liquid aligns exactly with the required volume mark on the pipet. -
Page 8: Replacing The Filter
Batteries charging is indicated by successive lighting of “bars”. 3. Full charging time: 7 to 8 hours. 4. The batteries are charged when all 3 “bars” are displayed simultaneously (Figure 5.1). CORNING STRIPETTOR ULTRA PIPET CONTROLLER... -
Page 9: Maintenance
The Corning Stripettor Ultra Pipet Controller (Cat. No. 4099) comes with a universal charger and a set of adapters in different versions: EU, US, UK, and AU. Choose your country’s adapter and connect to the housing. -
Page 10: Components
During breaks in the work the pipet controller can be stored on the wall hanger or charging stand. The Corning® Stripettor® Ultra charging stand is a device intended to conveniently charge and store a pipet controller when not in use. Three positions (Figure 9) to store the pipet controller, depending on user needs, are also visible as icons printed on the stand. -
Page 11: Limited Warranty
This warranty gives you specific legal rights. You may have other rights which vary from state to state. No individual may accept for, or on behalf of Corning, any other obligation of liability, or extend the period of this warranty. - Page 12 55 (11) 3089-7400 Taiwan t 886 2-2716-0338 Mexico t (52-81) 8158-8400 For a listing of trademarks, visit www.corning.com/clstrademarks. All other trademarks are the property of their respective owners. © 2015-2023 Corning Incorporated. All rights reserved. 7/23 CLS-EQ-113 (H-STR-IM) REV3...
Need help?
Do you have a question about the Stripettor 4099 and is the answer not in the manual?
Questions and answers