CORNING Stripettor Pro Quick Start Manual

Pipet controller

Hide thumbs Also See for Stripettor Pro:

Download this manual

Corning

Pipet Controller

Quick Start Guide

Battery Charge

Speed Setting

SPEED

Approximated time

of aspirating 25 mL

of distilled water.

Stripettor

Speed level

Speed value

Pro

Level (LOW-HIGH)

Click SPEED to change

Speed value (1-3 bars)

· Hold SPEED for 3 sec.

· Press SPEED to change

· Hold SPEED for 3 sec. to accept

The speed can be controlled by

pressing the trigger buttons as well.

LOW

approx. 3 hours

HIGH

6.3 s

4.4 s

5.6 s

3.8 s

5.0 s

3.1 s

Need help?

Do you have a question about the Stripettor Pro and is the answer not in the manual?

Page 1 Corning Stripettor ® ® Pipet Controller Quick Start Guide Battery Charge approx. 3 hours Speed Setting Level (LOW-HIGH) Click SPEED to change Speed value (1-3 bars) · Hold SPEED for 3 sec. · Press SPEED to change SPEED · Hold SPEED for 3 sec. to accept The speed can be controlled by pressing the trigger buttons as well.
Page 2 Mode Control Click MODE to change between Gravity (drop) MODE and Blow out (arrow) mode Aspirating and Dispensing The speed depends on how deep the button is pressed. Maintenance UV sterilization Autoclave Isopropyl alcohol Min. 50 cm ONLY 121°C for 15 min.
Page 3 Filter Replacement Storage Safety Information WARNING: Risk of injury CAUTION Risk of damage to the device or errors in pipetting of liquids. Before starting the work with the pipet controller every user should read the operating instructions carefully. CAUTION: • Using the device inconsistently with the operating instructions may result in damaging the device.
Page 4 For additional product or technical information, visit www.corning.com/lifesciences or call 800.492.1110. Outside the United States, call +1.978.442.2200. For a listing of trademarks, visit www.corning.com/clstrademarks. All other trademarks are the property of their respective owners. © 2024 Corning Incorporated. All rights reserved. 5/24 CLS-AN-818DOC REV1...