Beatbot AquaSense Manual

Product Structure Diagram

1. Push-to-open Switch
2. Filter Basket Cover
3. Water Outlet
4. Ultrasonic Smart Sensor*2
5. Handle
6. Track Wheel*2
7. Dual Roller Brush*2
8. Filter Basket
9. Mode Button
10. Panel Indicator

Robot Button

• Hotspot Configuration
  Press and hold both "Quick Mode" () + "Power" () buttons for about 3s to trigger the hotspot configuration.
• Factory Reset
  Press and hold the "Quick Mode" (), "Power" () and "Standard Mode" () buttons simultaneously for about 10s to restore the factory settings.

APP

APP Download
You can either scan the QR code below or search for "Beatbot" in the App Store or Google Play to download the APP.

Robot Connection
Please check the following items before connecting:

• Make sure the robot is turned on;
• Confirm that both your mobile phone and the robot are within the same Wi-Fi coverage range with a strong signal;
• Ensure your phone is connected to Wi-Fi, supporting only the 2.4GHz network;
• Keep the phone close to the robot (within 1m distance).

After powering on, press the "Power" and "Quick Mode" buttons simultaneously for about 3s, and when you see the indicator flashing blue, the robot is ready for network setup. Then, choose either of the following methods to complete the connection:

1. Scan to add:
   Tap the "Scan to Add" on the home page of the App, aim the camera at the QR code on the robot and follow the App instructions to complete the connection.
   
   OR
2. Add manually:
   Tap the "Add Device" on the home page of the App, choose your robot model, and follow the App instructions to complete the connection.
   

Preparation Before Use

Charging

1. Install the charge dock
   
2. Plug into the power supply
   
3. Place the robot
   
4. Charging
   

Before Cleaning

Before entering the water, it is crucial to place the robot on a level ground and to wait for about 5s for it to calibrate. By following these steps, you ensure maximize the effectiveness of the robot's cleaning path. The robotic pool cleaner will automatically disconnect from the phone after entering the water.

1. Ensure the robot has sufficient power (the indicator shows solid green).
   
2. Set the cleaning mode, and the selected mode button will show solid white.
   
3. Place the robot on a level ground and wait for about 5s for it to calibrate.
   
4. Place the robot in the water to start automatic cleaning.
   

After the cleaning task is completed, the robot will automatically dock on the surface next to the wall. If the robot is pulled out with a hook during cleaning and does not have enough time to drain, it may not be able to surface automatically as intended. Please continue to let the robot drain for 2-3 minutes.
Tips
If this is your first time using the pool this season, we recommend that you clean it manually first by removing any large debris. After that, you can use the robotic pool cleaner to maintain the cleanliness. This is because if there's a lot of debris left in the pool during the off-season, using the robot will cause the filter basket to clog more quickly and require more frequent cleaning. Therefore, it's more convenient to start with manual cleaning.
Each machine undergoes thorough testing, including underwater testing, before leaving the factory. As a result, there may be some residual water stains, which is normal. Please feel free to use it.

Reach out to us is easy!
service@beatbot.com
www.beatbot.com
For North America: (833) 702-4399
Mon-Sun 9:00 am-6:00 pm (CST)