Saber light ATD-80005 Owner's Manual

Features And Specifications:
•
New electronic ballast for brighter light and increased durability
•
26W super bright fluorescent bulbs provide 250 Lux brightness
•
50 ft 16/3 SJTOW cord remains flexible in cold weather and is oil & grease resistant
•
High impact shatter‐proof housing
•
Drop resistant with high impact Lexan lens
•
Ergonomic handle for a more secure grip
•
Equipped with rubber impact cover for added drop protection
•
Tool tap outlet with power indicator & overload protection
•
Includes 360° flexible ratcheting hook
Operating instructions
Simply plug into any 120 VAC outlet and turn on by pressing the on off switch located on the back of the handle.
To Change Bulb:
•
Unplug unit from power source.
•
Remove rubber impact cover.
•
Unscrew two screws from lens.
•
Open lens cover (A) and grasp end of bulb (B) and pull straight out.
•
Slide new bulb into socket making sure that it seats all the way into the socket
•
Put lens into place and replace screws
•
Replace rubber impact cover
Cautions
•
Do NOT overload circuit – Do not plug in more than 1500 watts or 12 amps into the base of this light. Check the amperage rating of the tool or
appliance that you are using before connecting anything to the outlet(s) on this product to be sure that you are not overloading the circuit.
•
Do NOT service this reel light while it is plugged in. It may cause electrical shock
•
Do NOT submerge in water. – It may cause electrical shock and/or fires. To clean, wipe with damp cloth only, do not use solvents, and clean only
when the unit is unplugged from power source.
•
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by
the operator.
26 Watt Quad Light w/50' Cord
Made in China to ATD Tools, Inc. Specifications
ATD‐80005
Owner's Manual