1369/2017........................43 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler - features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
– working environments; by clients in hotels, motels, bed & breakfast and – other residential type environments; areas for communal use in blocks of flats or in – launderettes. Do not exceed the maximum load of 9 kg (refer to the •...
ENGLISH • Do not install or use a damaged • Do not touch the mains cable or the appliance. mains plug with wet hands. • Do not install or use the appliance • Do not pull the mains cable to where the temperature can be less disconnect the appliance.
• Make sure that all metal objects are • Disconnect the appliance from the removed from the laundry. mains electrical and water supplies. • Cut off the mains electrical cable 2.5 Service close to the appliance and dispose of •...
Page 7
ENGLISH Make sure not to damage the hoses. • A (FRONT) = Front of the appliance 7. Remove the polystyrene protection • B (BACK) = Rear of the appliance from the bottom. 10. Remove the adhesive strip from the silent barriers. 11.
Make sure that the appliance does not touch the wall or other units. 2. Loosen or tighten the feet to adjust the level. WARNING! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level.
ENGLISH 3.3 The inlet hose The red sector in the window «A» shows this fault. 1. Connect the water inlet hose to the back of the appliance. 2. Position it toward left or right depending on the position of the water tap.
5. Without the plastic hose guide, to a sink spigot - Put the drain hose in Make sure that the drain the spigot and tighten it with a hose end is not immersed in clamp. Refer to the illustration.
ENGLISH then fabric softener in the water The Pára plus option, finishes every before they are distributed in the cycle with gentle steam that relaxes laundry. So every fibre is reached and the fibres and reduces fabric creasing. cared for. Ironing will be easier! •...
Compartment for liquid additives (fabric conditioner, starch). Compartment for salt. Salt Read carefully 'The Water Softener technology ( Soft Water)'. Maximum level for detergent/ Salt additives quantity. When selecting a prewash phase, put the detergent/ Compartment for washing phase: additive in a dosing ball powder detergent, stain remover.
ENGLISH 3. Touch the Skvrny/Předpírka and the condition. However, if the inlet water is Pára plus buttons simultaneously (by particularly hard (C06 and C07 levels), touching the two buttons at the same we suggest to set the water softener also instant, as shown in the next drawing) during rinsing phase to preserve the for some seconds until the display...
Page 14
Levels Water hardness range °f °d °e (French de- (German de- (English de- mmol/l grees) grees) grees) ≥46 ≥26 ≥33 ≥4.6 ≥460 1) Factory setting, able to satisfy most of the use conditions. 5.3 Pouring salt The water softener function acts through special resins present in the appliance.
ENGLISH 5.4 Water softener WARNING! regeneration Do not put anything but salt Salt After a few cycles, the appliance may in the compartment . If need to regenerate the water softener. any other detergent/additive is poured inadvertently in The regeneration process takes place this compartment, please automatically when long cycles are used refer to 'Eliminating...
7. CONTROL PANEL 7.1 Control panel description 11 10 Programme dial Extra rinse touch button (Máchání+) Display Delay start touch button (Odložený Energy saving touch button (Eco) start) Super steam touch button (Pára plus) Time saving touch button (Úspora času)
Page 17
ENGLISH 7.2 Display Maximum load indicator. The icon flashes during laundry load esti- mation (refer to "PROSENSE load detection" paragraph). Maximum laundry indicator. It flashes when the laundry load exceeds the maximum declared load of the selected programme. Salt Salt refilling indicator. The compartment needs salt refilling: the com- partment is empty or the salt is not enough.
Anti-crease phase indicator. Child safety lock indicator. Time saving indicator. Temperature indicator. The indicator appears when a cold wash is set. Spin speed indicator. Rinse hold indicator. Extra silent indicator. Pre-wash indicator. Stain indicator. Extra rinse indicator. 8. DIAL AND BUTTONS 8.1 On/Off...
Page 19
ENGLISH 8.5 Skvrny/Předpírka When the display shows the indicators , the appliance does not Press this button repeatedly to activate heat the water. one of the two options. 8.4 Odstřeďování The relevant indicator goes on in the display. When you set a programme, the appliance automatically selects the •...
Page 20
If the Máchání+ is set as a If you select the Cotton default option and you programme at 40°C or 60°C select a compatible washing and no other options are set, programme, the display the display shows the shows .
ENGLISH 8.11 Odložený start the selected delay time and the appliance begins the countdown. With this option you can delay the start of a programme in a more convenient 8.12 Start/Pauza time. Touch the Start/Pauza button to start, Touch the button repeatedly to set the pause the appliance or interrupt a required delay.
Page 22
Programme Programme description Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol Vlna/Hedvábí Steam programme Steam programme for cotton and synthetic items. Steam can be used for dried , washed or worn once laundry. This Pára...
Page 23
ENGLISH Programme Programme description Do not use fabric softener and make sure that Outdoor there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.5 kg. This programme can also be used as water-repellent restoring cycle, specifically tailored for treating clothes with a hydropho- bic coating.
Page 24
Programme Default temperature Reference spin Maximum load Temperature range speed Spin speed range 1.5 kg Pára 30 °C 1400 rpm 5 kg 60 °C - 30 °C 1400 rpm - 400 rpm ÖKOPower 1400 rpm 60 °C 9 kg 1400 rpm - 400 rpm Antialergický...
• You deactivate the appliance (special • To activate/deactivate this option short tune). touch the Máchání+ button and the • You touch the buttons (click sound). Volba button simultaneously the • You make a wrong selection (3 short relevant indicator comes on/goes off.
ENGLISH 11.3 Filling the detergent and additives We recommend that you do not exceed the maximum indicated level ( 1. Open the detergent dispenser. Filling the liquid detergent 1. Insert the proper container for liquid detergent. 2. Put the powder detergent in the compartment .
1. Touch the Start/Pauza button to speed, the washing phase indicators pause the appliance. The related (when available) and an indicative indicator flashes. programme duration. 2. Touch the Odložený start button 2. To change the temperature and/or...
ENGLISH Once removed the exceeding garments, The anti-crease phase is running: touch the Start/Pauza button to start the programme again. The ProSense phase can be repeated up to three times (see point 1). 11.9 Interrupting a Important! If the laundry amount will not programme and changing the be reduced, the washing programme options...
11.13 Draining water out after If the temperature and level end of cycle of the water in the drum are too high and/or the drum If you have chosen a programme or an still rotates you cannot open option that does not empty out the the door.
ENGLISH Press the On/Off button to activate If you set a programme or an the appliance again. option that ends with water The display shows the end of the last in the drum, the Stand-by set programme. function doesn't deactivate Turn the programme dial to set a new the appliance to remind you cycle.
• Always start a washing programme with the maximum load of laundry the indicated maximum level ( allowed. • Use the recommended detergents for • If you pre-treat the stains, you can use the type and colour of the fabric, the...
ENGLISH 13.5 Cleaning the drum Regularly examine the drum to prevent unwanted deposits. Rust deposits in the drum may occur due to rusting foreign body in the washing or tap water containing iron. Clean the drum with special products for stainless steel.
4. Make sure that all detergent residue Regularly check the drain is removed from the detergent pump filter and make sure conveyor. Use a cloth. that it is clean. Clean the drain pump if: • The appliance does not drain the water.
Page 35
ENGLISH rotate, contact the Authorised Service Centre. 4. Turn the filter 180 degrees in anti- clockwise direction to open it, without removing. Let the water flow 10. Clean the filter under the water tap. out. 11. Put the filter back into the special guides by turning it clockwise.
When you drain the water with the 3. Clean the valve filter on the back of emergency drain procedure, you must the appliance with a toothbrush. activate the drain system again: a. Put 2 litres of water in the main wash compartment of the detergent dispenser.
ENGLISH 1. Put 2 litres of water in the main wash 3. Put the two ends of the inlet hose in compartment of the detergent a container and let the water flow out dispenser. of the hose. 2. Start the programme to drain the 4.
Contact the Authorised WARNING! Service Centre. Deactivate the appliance before carrying out any check. 14.2 Possible failures Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed.
Page 39
ENGLISH Problem Possible solution • Make sure that the couplings of the water hoses are tight and there is not water leakages. There is water on the • Make sure that the water inlet hose and the drain hose have floor.
Problem Possible solution • The appliance may need a water softener regeneration: run a long cycle without reducing time. Refer to "Water soften- Salt is not consumed. er regeneration" in "The Water Softener (Soft Water)" chapter. After the check, activate the appliance. The programme continues from the point of interruption.
ENGLISH 2. Eliminate any trace of detergent or additive and clean the compartment thoroughly. 3. Insert the drawer back and pour salt Salt in the compartment 4. Close the drawer. 5. Run a cotton or synthetic cycle, without reducing time, to restore the water softener function.
Programmes Load Energy Water Approxi- Remain- (kg) consump- consump- mate pro- ing mois- tion (kWh) tion (litre) gramme ture (%) duration (minutes) 0.24 Standard 40°C cotton 1) At the end of spin phase. 2) The performance results and low energy consumption are guaranteed by the use of softened water.
Read carefully the instructions supplied top of the washing machine only by with the accessory. using the correct stacking kit manufactured and approved by AEG. 18. PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION 1369/2017 Product Information Sheet Trade Mark...
Page 44
Model L9FEC49SC, PNC914550908 Rated capacity in kg Energy efficiency class A+++ Energy consumption in kWh per year, based on 220 standard washing cycles for cotton programmes at 60 °C and 40 °C at full and partial load, and the consumption of 65.0...
ENGLISH Airborne acoustical noise emission in db(A) spinning Built in appliance Y/N The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC . 19. ENVIRONMENTAL CONCERNS appliances marked with the symbol Recycle materials with the symbol with the household waste.
Need help?
Do you have a question about the L9FEC49SC and is the answer not in the manual?
Questions and answers