Download Print this page
U-Line H-11721 Manual
U-Line H-11721 Manual

U-Line H-11721 Manual

Economy evaporative cooler

Advertisement

Available languages

Available languages

Quick Links

H-11188, H-11721
ECONOMY EVAPORATIVE
COOLER
TOOL NEEDED
Phillips Screwdriver
Locking Caster x 2
• Read and follow all instructions, cautions and
warnings. Failure to do so could result in personal
injury, death or property damage.
• Unit must be in "OFF" position and unplugged
from power receptacle before performing any
maintenance or service or before removing access
panels.
• Ensure electrical power source conforms to local
codes and evaporative cooler requirements.
• Do not touch electrically live components.
• Ensure all power cords do not touch sharp edges,
hot surfaces or chemicals. Immediately replace
damaged parts.
PAGE 1 OF 12
1-800-295-5510
uline.com
PARTS
Swivel Caster x 2
SAFETY
• Never leave unit unattended.
• Continuous fill should not be used indoors or
• After unpacking, carefully inspect for any damage
• Inspect for loose, missing or damaged parts.
• Wheels and hardware are located in a
• Contact Uline Customer Service at 1-800-295-5510
Pour le français, consulter les pages 9-12.
Hose Adapter x 1
unattended.
that may have occurred during transit.
compartment on the bottom side of cooler.
to request replacement parts if any parts are
missing.
Para Español, vea páginas 5-8.
Screw x 16
1124 IH-11188

Advertisement

loading
Need help?

Need help?

Do you have a question about the H-11721 and is the answer not in the manual?

Questions and answers

Summary of Contents for U-Line H-11721

  • Page 1 Para Español, vea páginas 5-8. Pour le français, consulter les pages 9-12. H-11188, H-11721 1-800-295-5510 uline.com ECONOMY EVAPORATIVE COOLER TOOL NEEDED Phillips Screwdriver PARTS Locking Caster x 2 Swivel Caster x 2 Hose Adapter x 1 Screw x 16 SAFETY •...
  • Page 2: Caster Installation

    SETUP CASTER INSTALLATION FILLING THE TANK Lay unit upside down. Remove screws and panel on NOTE: Unit must be in an upright and level bottom of unit using Phillips screwdriver. (See Figure 1) position before filling. HOSE FILL Figure 1 NOTE: Do not use hose adapter indoors.
  • Page 3: Operation

    OPERATION 1. Turn pump switch to "ON" position. Water will begin to STARTING PUMP AND FAN flow down to media pads. NOTE: Ensure tank is full before turning on. 2. Turn fan switch to desired speed. NOTE: Ensure caster brakes are engaged. MAINTENANCE CLEANING REMOVAL OF RIGID MEDIA...
  • Page 4: Troubleshooting

    TROUBLESHOOTING OPERATING ISSUE RECOMMENDATIONS Cooler will not turn on. Ensure unit is plugged in and switched on. Receptacle breaker may need to be reset. Reset GFCI plug if applicable. Ensure timer is off. Unit may need on/off switch replacement. Fan will not operate. Ensure fan is on.
  • Page 5: Herramienta Necesaria

    H-11188, H-11721 800-295-5510 800-295-5510 uline.mx uline.mx ENFRIADOR EVAPORATIVO ECONÓMICO HERRAMIENTA NECESARIA Desarmador de Cruz PARTES 2 Ruedas con Seguro 2 Ruedas Giratorias 1 Adaptador de 16 Tornillos Manguera SEGURIDAD • Lea y siga todas las instrucciones, precauciones • Nunca deje la unidad desatendida.
  • Page 6: Instalación De Las Ruedas

    INSTALACIÓN INSTALACIÓN DE LAS RUEDAS LLENAR EL TANQUE 1. Coloque la unidad boca abajo. Retire los tornillos NOTA: La unidad debe estar en una posición y el panel en la parte inferior de la unidad con un vertical y nivelada antes de llenarla. desarmador de cruz.
  • Page 7: Mantenimiento

    FUNCIONAMIENTO 1. Gire el interruptor de la bomba en la posición ENCENDER LA BOMBA Y VENTILADOR "ON" (Encendido). El agua empezará a fluir a NOTA: Asegúrese de que el tanque esté las almohadillas de los soportes. lleno antes de encender. 2.
  • Page 8: Solución De Problemas

    SOLUCIÓN DE PROBLEMAS PROBLEMA DE FUNCIONAMIENTO RECOMENDACIONES El enfriador no se enciende. Asegúrese de que la unidad está enchufada y encendida. El cortacircuitos del receptáculo podría necesitar reiniciarse. Reinicie el enchufe GFCI si aplica. Asegúrese de que el temporizador esté apagado. La unidad podría necesitar un reemplazo del interruptor de encendido/apagado.
  • Page 9: Outils Requis

    H-11188, H-11721 1 800 295-5510 uline.ca REFROIDISSEUR PAR ÉVAPORATION ÉCONOMIQUE OUTILS REQUIS Tournevis cruciforme PIÈCES Roulette blocable x 2 Roulette pivotante x 2 Adaptateur de tuyau x 1 Vis x 16 SÉCURITÉ • Lire et suivre toutes les instructions, consignes et •...
  • Page 10: Installation Des Roulettes

    INSTALLATION INSTALLATION DES ROULETTES REMPLISSAGE DU RÉSERVOIR Posez l'appareil à l'envers. Retirez les vis et le REMARQUE : L'appareil doit être en position panneau sous l'appareil à l'aide du tournevis verticale et de niveau avant d'être rempli. cruciforme. (Voir Figure 1) REMPLISSAGE AVEC UN TUYAU Figure 1 REMARQUE : N'utilisez pas l'adaptateur de...
  • Page 11: Entretien

    FONCTIONNEMENT 1. Mettez l'interrupteur de la pompe en position DÉMARRAGE DE LA POMPE ET DU VENTILATEUR « ON » (marche). L'eau commence à s'écouler REMARQUE : Veillez à ce que le réservoir soit vers les tampons. plein avant de mettre l'appareil en marche. 2.
  • Page 12: Dépannage

    DÉPANNAGE PROBLÈME RECOMMANDATIONS Le refroidisseur ne se Assurez-vous que l'appareil est branché et allumé. met pas en marche. Il peut être nécessaire de réinitialiser le disjoncteur de la prise de courant. Réinitialisez la fiche DDFT, le cas échéant. Assurez-vous que la minuterie est désactivée. L'appareil peut nécessiter le remplacement de l'interrupteur marche/arrêt.

This manual is also suitable for:

H-11188