Page 1
(NAA) Instructions for Use For your safety: read and understand manual before use. At least one copy of this manual should be kept in a location available at all times to maintenance and management staff. JURA Type 773...
Setting up the machine ................... Filling the bean container ..................Determining the water hardness ................First-time use ......................Managing your W8 – the JURA Cockpit ..............Connecting milk ..................... 4 Preparation ......................Preparation with preselection (Specialty Selection) ............Latte macchiato, cappuccino and other specialty coffees with milk ........
Page 3
Table of contents 8 Display messages ....................9 Troubleshooting ....................10 Transport and environmentally friendly disposal ............Transport / Emptying the system ................Disposal ......................11 Technical data ..................... 12 Index ........................13 JURA contact details / Legal information ..............
1 IMPORTANT SAFEGUARDS 1 IMPORTANT SAFEGUARDS Comply with the Failure to observe the instructions for use may result in serious instructions for use injuries or damage to property. Safety information is therefore indicated as follows: This is the safety alert symbol. lt is used to alert you to potential personal injury hazards.
Page 5
It shall only be used for coffee preparation and to heat milk and water, according to these instructions. Use for any other purpose will be deemed improper. JURA Elektroapparate AG cannot accept any responsibility for the consequences of improper use. People, including children, who...
Page 6
Repair MUST be done by authorized personnel only. In the event of signs of damage, for example if there is a smell of burning, unplug the machine immediately from outlet and contact JURA customer service. J CAUTION Office building, hotel maintenance and management staff must ensure that servicing should be performed by an authorized service facility only.
Page 7
1 IMPORTANT SAFEGUARDS NOTICE Never clean with scouring powders or hard implements. Ensure that the ventilation slots are not covered. Never pull out the drip tray during the brewing process. Only pull the drip tray when the display instructs you or when the appliance is ready for use.
2 Control elements 2 Control elements 17 18 J HOT J HOT J HOT...
Page 9
Power cord (permanently connected or plug-in) (back of the machine) Coffee grounds container Water tank Water tank cover (lockable) Service socket for an optional JURA Connector Filler funnel for ground coffee (removable) Filler funnel cover Grinder adjustment switch Container for milk system cleaning...
Choose a spot for your W8 which protects the machine against overheating. Ensure that the ventilation slots are not covered. Place the W8 on a horizontal surface that is not sensitive to water (minimum height of 31.5 in. (80 cm)).
For machines with a plug-in power cord: Connect the power cord to the machine. Insert the power plug into a power socket. Press the On/Off button Q to switch the W8 on. ‘Choose language’ Press the button until the desired language is displayed, e.g.
‘Empty drip tray’ Empty the drip tray and put it back into the machine. The start screen is displayed. Your W8 is ready for use. Managing your W8 – the The JURA Cockpit allows you to manage your W8.
Remove the protective cover from the fine foam frother. Connect the milk pipe to the fine foam frother. E The milk system of your W8 has a connector HP3 and an interchangeable milk spout CX3. Connect the other end of the milk pipe to a milk container or a milk cooler.
‘X’ button Coffee tastes best served hot. A cold porcelain cup cools the beverage – and impairs the taste. We therefore recommend prewarming the cups. You can purchase a JURA cup warmer from your specialized dealer. Preparation with Press the button to open the Specialty Selection.
The preset amount of water for coffee flows into the cup. Americano and lungo For the americano and lungo, the W8 blends the coffee with hot water using a special preparation method. This results in a full-bodied specialty coffee which is particularly easy to digest. You can change the amount of this additional water (see chapter 4 ‘Preparation –...
4 Preparation Press the button. Press ‘Espresso’ (on page ö ä ä). ‘Please add ground coffee’ Open the cover of the filler funnel for ground coffee. Place one level measuring spoon of ground coffee into the filler funnel. ...
Press the On/Off button Q. ‘Machine is rinsing’ Your W8 is switched on or off. E When the machine is switched off, the system is only rinsed if a specialty coffee has been prepared. E If milk has been prepared before switching off, you will be prompted to carry out a milk system cleaning (‘Clean the...
Remove the water tank and rinse it with cold water. Fill the water tank with fresh, cold water and reinsert the tank. Maintenance actions Optimal coffee quality depends on many factors. One important prerequisite is regular maintenance of your W8. Carry out the following steps: Maintenance action Daily...
Specify whether or not to allow one-off settings during preparation ‘Lock/enable’ Enable or disable individual products ‘Product settings’ Define whether the permanent product settings can be changed or not If a JURA Connector is used in the service socket of the W8, further functions appear on page ä ä ä ö.
Cockpit. You can manage the maintenance of your W8 in section. In the Cockpit of your W8, maintenance programs that need to be carried out are shown in the form of messages with red backgrounds. Press the button that corresponds to the message to go straight to the maintenance program.
7 Maintenance Rinsing the milk system After each milk preparation, the W8 prompts you to perform a milk system rinse. In the machine settings, you can set whether the milk system rinsing is to be initiated manually or automatically 15 minutes after preparation (see chapter 6 ‘Machine settings’).
Rinse all the parts under running water. If there are severely dried-on milk residues, firstly immerse the individual parts in a solution of 8.5 oz (250 ml) water and one dosing unit of JURA milk system cleaner. Then rinse the individual parts thoroughly.
Once the filter cartridge stops working (depending on the water hardness setting), the W8 will prompt you to change the filter. E Your W8 no longer has to be descaled if you are using the CLEARYL Pro Smart+ filter cartridge.
7 Maintenance Cleaning the machine After 180 preparations or 80 switch-on rinses, the W8 will prompt you to clean it. J WARNING Non-recommended (e.g. liquid) cleaning agents may contain substances that could damage the machine or leave residues. Use only original JURA cleaning tablets. These are formulated especially for your machine.
Empty the drip tray and coffee grounds container and put them back into the machine. Descaling the machine The W8 builds up deposits of limescale over time and automatically prompts you to descale it when necessary. The degree of calcification depends on the hardness of your water.
7 Maintenance Precondition: The cockpit displays ‘Descale’. Press the button for approx. 2 seconds to enter the JURA Cockpit. Press ‘Descale’. Press the ‘Start’ button. ‘Empty drip tray’ Empty the drip tray and coffee grounds container and put them back into the machine.
7 Maintenance If you use a CLEARYL Pro Smart+ filter cartridge, remove this. Completely fill the water tank and dissolve 3 JURA descaling tablets in it. Leave the water tank with the descaling solution for several hours (e.g. overnight).
(see chapter 7 ‘Maintenance – lights up red. Inserting/changing the filter’). ‘Filter’ ‘Clean’ The W8 is prompting you Perform cleaning (see chapter 7 to clean it. ‘Maintenance – Cleaning the machine’). ‘Descale’ The W8 is prompting you Perform descaling (see chapter 7 to descale it.
(see chapter 13 ‘JURA contact details / Legal information’). 10 Transport and environmentally friendly disposal Transport / Emptying the Keep the packaging for your W8. It should be used to protect the system machine during transport. In order to protect the W8 from frost during transport, the system must be emptied.
Remove and empty the water tank. ‘System is emptying’ Steam will continue to be discharged from the fine foam frother and the hot-water spout until the system is empty. Your W8 is switched off. Disposal Please dispose of old machines in an environmentally neutral way.
Need help?
Do you have a question about the W8 and is the answer not in the manual?
Questions and answers