Installation Instructions; Install Cooktop - Whirlpool G7CG3064XS Installation Instructions Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.
1. Determine whether your cabinet construction provides
clearance for installing clamping brackets at cooktop base
ends. This is the recommended location. Clamping brackets
can be installed on the front and back of cooktop base
bottom, if necessary.
A
A. Attachment screw holes for optional front and back location
B. Cooktop base bottom
C. Attachment screw
D. Clamping bracket (end locations recommended)
2. Using 2 or more people, place cooktop right side up into the
cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from cutout to avoid scratching
the countertop.
3. Remove the attachment screws for the selected bracket
locations from the bottom of the cooktop base.
A. Edge of cooktop base bottom
B. Clamping bracket
8

INSTALLATION INSTRUCTIONS

Install Cooktop

B
C
D
C
A
B
4. Attach brackets to cooktop base bottom with bracket
attachment screws. Securely tighten screws.
A
B
A. Cooktop
B. Cooktop base
C. 2" (5.1 cm) bracket attachment screw
D. Clamping bracket (extends far enough beyond cooktop
base to allow installation of clamping screws)
E. Countertop
NOTE: There will be a small gap (approximately
between the cooktop and the countertop. This is normal. See
the following illustration.
A
A. Small gap (approximately
between cooktop and countertop
E
D
C
" [3 mm])
" [3 mm])