GE JGP963 - Profile 36" Deep Recessed Gas Cooktop Installation Instructions Manual page 14

MAKING THE LP CONVERSION
CHANGE COOKTOP BURNER
3
ORIFICES
Remove the top grates, burner caps,
A
burner heads and burner bases.
B Remove the
electrodes from the
burner base. Using
a No. 15 "Torx" head
driver bit, remove
the screws holding
the burner base in
position.
Using a 7mm or
C
9/32" nut driver,
remove the top
burner orifices.
These may be
accessed through the
hole in the cooktop.
NOTE: The orifices have
a spring-loaded retaining
ring around the hex head
to hold the orifice in the
nut driver during
installation and removal.
A slight amount of force is required to push
the nut driver down over the ring.
D Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter
"L" on the side. (Important: Save the
orifices removed from the appliance
for future use.)
Each orifice will show a series of
engraved marks, (I, II, III or X),
located on the top.
I II
These marks denote the precise location of
each orifice to the cooktop burner.
Installation Instructions
Remove
This
Assembly
Orifice Spud Located
Through This Opening
Retainer
Ring
III X
14
(CONT.)
Units with 4 burners
Units with 5 burners
E Install the LP/Propane orifices in
their precise locations as noted in the
illustrations above.
F Replace the burner bases, heads, caps
and top grates. (NOTE: When re-attaching
the burner bases to glass top units,
tighten screws to a maximum of
10 in.-lbs torque.)
G
Save the orifices removed from the
appliance for future use.
X