GE JGP633SETSS Installation Instructions Manual page 14

MAKING THE LP CONVERSION
CHANGE COOKTOP BURNER
3
ORIFICES
Remove the top
A
grates, burner caps,
and burner heads.
B Remove the spark
igniters from the
burner base (if
required to access
the orifices). Using a
No. 15 "Torx" head
driver bit, remove the
screws holding the
burner base in
position.
C Using a 7mm nut
driver, remove the
top burner orifices.
These may be
accessed through the
hole in the cooktop.
Installation Instructions
Remove
This
Assembly
Orifice Spud Located
Through This Opening
Burner cap
Burner
head
Burner
base
Spark igniter
18,000 BTU Burner
(on some models)
Burner
cap
Burner
head
Burner
base
Spark igniter
14
(CONT.)
CHANGE COOKTOP BURNER
3
ORIFICES (CONT.)
NOTE: On most burners,
the orifices have a spring-
loaded retaining ring
around the hex head to
hold the orifice in the nut
driver during installation
and removal. A slight amount of force is
required to push the nut driver down over
the ring.
Retainer
Ring