Quest Engineering XPOINTER II Quick Start

STRUCTURE
Pinpoint Tip
Side scan area
Search light LED
Indication LED
Power button
Mode button
Battery cover
Anchor loop
QUICK START
POWER ON/OFF
Press the power button once to turn on the pinpointer. A long
and two short sounds will be heard.
The white search light is on defaulted when the pinpointer is
powered on, but if the search light is deactivated, it will be off
when the pinpointer is powered on.
The pinpointer will automatically retune itself when switched
on, so please keep the pinpointer away from metal objects
when power it on.
To power off the pinpointer, press and hold the power button
for 1 second. When the pinpointer is turned off, all the
settings will be saved automatically.
SEARCHING
Move the pinpointer in circle or cross style to pinpoint.
SYNC (OPTION)
Most VLF metal detectors work very well with the Xpointer II
but due to the Pointers powerful pulse technology some
detectors may chatter when you turn your Xpointer II on. To
remedy this, simply perform the "noise cancel" function on
your detector (as found on detectors like E-trac) or mannually
select a channel (as done with the AT Pro,T2) that does not
react with your Xpointer.
Warning
Positive buoyant, hook it with lanyard.
XPOINTER II
EU Declaration of Conformity
Hereby, Dongguan Quest Detection Technology Co.,
Limited declares that this radio equipment is in
compliance with directive 2014/53/EU. The full text
of the EU declaration of conformity is available at
the following address:
www.detectorportal.eu/compliance
DO & DON'T
• Always make sure the battery cap is secured tightly
before entering water .
• Always store your pinpointer fully charged.
• Always rinse equipment in fresh water after every
hunt.
• Always Make sure the tail cap thread and O ring are free
of dust, mud, sediment, etc. Always remember to keep the
tail cap thread and O-ring lubrcited with silicone grease to
maintain a tight seal.
• Only open battery cap by clean hand.
• Never leave your equipment in the rinse bucket. It may
be damaged by other equipment.