Sonoff iFan03 Manual

Operating Instruction

1. Power off
   To avoid electric shocks, please consult the dealer or a qualified professional for help when installing and repairing!
   
2. Wiring instruction
   Please install protection devices before connecting the live wire. (e.g. fuses or air switches).
   Make sure the neutral wire and live wire connection is correct.
   
3. Download the eWeLink APP
   
   
   
   Android™ & iOS
   
4. Power on
   After powering on, the device will enter the quick pairing mode (Touch) during the first use, then the fan makes two short beeps and one long beep.
   If not paired within 3mins, the device will exit the quick pairing mode (Touch). If you need enter again, long press the "pairing button" on the controller or "Wi-Fi pairing button" on the RM433 remote controller and hold 5s until the fan makes two short and one long "bi" sound and release.
   
5. Add the device
   Tap "+" and select "Quick Pairing", then operate following the prompt on the APP.
   

Pairing method for the device and SONOFF RM433 remote controller:

Please press any button within 5s after powering on again untilthe ceiling fan makes a sound "di", and pairing is successful.
The device can pair with up to 10 remote controllers and the 11th remote controller data will cover the 1th.

Specifications

Product Introduction

The device weight is less than 1 kg.
The installation height of less than 2 m is recommended.

Features

Remotely turn on/off the device, schedule it on/off or share it with your family to control together.

Switch Network

If you need to change the network, Long press the "pairing button" on the controller or "Wi-Fi pairing button" on the RM433 remote controller and hold 5s until the fan makes two short and one long "bi" sound and release., then the device enters quick pairing mode and you can pair again.

Factory Reset

Deleting the device on the eWeLink app indicates you restore it to factory setting.

RM433 remote controller

Before operating the product, please press andpush down the back cover until it removes, thenpress the battery and pull out the insulation sheet.

The iFan03 supports the remote controller with 433.92MHz frequency brand to turn on/off, after pairing with one button, all buttons can control the connected device, which is local short-range wireless control not Wi-Fi control.

RF clearing method:
Long press for 5s until the ceiling fan makes two sounds "di di" to clear the code successfully.

Wi-Fi pairing method:
Long press for 5s until the fan makes two short and one long "bi" sound to enter the quick pairing mode (Touch). then you can add the light on eWeLink APP.
In quick pairing mode, you can short press any button on the remote controller to exit this mode.

Common Problems

Why my device stays "Offline"?

The newly added device needs 1 - 2mins to connect Wi-Fi and network. If it stays offline for a long time, Please judge the problem according to the following methods:

1. Maybe you have entered a wrong Wi-Fi password.
2. Maybe there's too much distance between the switch your router or the environment causes interference, consider getting close to the router. If failed, please add it again.
3. The 5G Wi-Fi network is not supported and only supports the 2.4GHz wireless network.
4. Maybe the MAC address filtering is open. Please turn it off.
5. Ensure steady enough network.
6. If none of the above methods solved the problem, you can open the mobile data network on your phone to create a Wi-Fi hotspot, then add the device again.