Subscribe to Our Youtube Channel
Related Manuals for GODIAG GT110
Summary of Contents for GODIAG GT110
- Page 1 GODIAG GT110 FOR VW Skoda Seat CAN-Bus UDS 4th Generation IMMO System Test Platform Cable User Manual 202501...
-
Page 2: Product Overview
Product Overview GODIAG GT110 for VW Skoda Seat CAN-Bus UDS 4th generation IMMO system test platform cable supports VW Skoda Seat and other models, and performs offline POGO PIN data reading and writing. lt is for dashboards key programming (including Boot Probe) of all UDS systems of Volkswagen, Skoda and Seat. - Page 3 Step 1: Connect the power supply [Note: the power switch must be off]. Step 2: Press the ignition switch first. Step 3: Connect GT110 to the instrument. Step 4: Find the POGO PIN connection point of the corresponding instrument and connect it with a probe.
- Page 4 By comparison, it is found that using POGO PIN to read FLASH data is much faster than not using POGO PIN to read FLASH data. VW GOLF Key Chip Matching with GODIAG GT110 & VVDI2 Step 1: Connect GT110, VVDI, computer and instrument as shown in the figure.
- Page 5 Step2: Then connect 12V power to GT110. Step 3: Then press the main power switch 1 and the ignition switch 2.
- Page 6 After pressing the ignition switch2, you can see that the dashboard displays SAFE. The light on the sensor adapter flashes for a long time and then goes out. This means that no matching key chip was identified. Next, start key matching. Step 4: Open the VVDI2 software on your computer and click VW.
- Page 7 Step 5: Then click “Diagnostic”>>”Diagnostic Unit”>>”17 Instruments”>>”Connect” Here you can read instrument information, clear fault codes, etc. Step 6: After exiting the “Diagnostic”, select “Key Learn”>>”4th immobilizer system-VW/Skoda/Seat”>>”Auto detect type”...
- Page 8 Step 7: Click"Diag">>Click"Read IMMO Data">>"Read EEPROM/FLASH">>""Make Dealer Key">>"Next"...
- Page 10 Step 8: Then follow the prompts to insert Xhorse VVDI super chip. Note: If the chip has been used, you need to erase it first.
- Page 11 Step 9: After inserting the chip, click “OK” to continue. Then the chip matching is successful.
- Page 12 Test the newly generated chip. Step 10: Put the chip into the induction adapter.
- Page 13 Step 11: Then press the main power switch 1, ignition switch 2 in order. After pressing the ignition switch, you can see the light on the induction adapter flash quickly and then go out immediately, and the instrument panel displays the specific mileage.
- Page 14 3. The light of the key identifier does not flash, which means that the vehicle's IMMO system is faulty. Please check the vehicle's IMMO system. Accessories: 1pc x GODIAG GT110 FOR VW Skoda Seat Test Platform Cable 1pc x PDF manual...
- Page 15 Shenzhen Sinoy Technology Co.,Ltd All Rights Reserved www.godiag.com +86 18813687743 Sales@GoDiag.com Thanks for reading!
Need help?
Do you have a question about the GT110 and is the answer not in the manual?
Questions and answers