Before Use - Morphy Richards STEAM GENERATOR Manual

Components of your
iron
stand by
anti-
replace
scale
Iron unit
Steam button
Temperature control dial
Sole plate
Temperature indicator light
Supply cord from base unit
Base unit
Anti-scale cartridge
Water tank
Power cord
Power switch
-Standby mode indicator (red)
-Power indicator (green)
-Sleep mode indicator
(green and red flashing alternate)
Replace anti-scale cartridge indicator
Steam level indicators
power
Location
Locate the steam generator horizontally on
the iron rest plate of your ironing board (if
large enough) or on a heat resistant stand at
the same height of your ironing board or
below it.
Always ensure the generator is on a firm
surface when ironing.

Before use

Remove any protective films or sticker from
the soleplate and the cabinet, if any.
When ironing with the steam facility at the 1
dot setting, the steam output should be set at
the lower end of the steam range.
Textiles and clothes are supposed to carry
ironing instructions. If they don't you should
follow the fabric guide on page 3, but be sure
to test the temperature by ironing the hem of
the garment or similar area first.
If you turn the control dial down from a hot
setting to a cooler setting, wait until the iron
temperature has stabilised before you
continue ironing.
Filling
1 Place the steam generator on a stable
ironing board or table, with the iron resting
on its stand.
2 Remove the detachable water tank by
sliding outwards.
FILL TO HERE
3 Remove the anti-scale cartridge by pulling
upwards.
4