3Com Access Point 8200 Quick Start Manual page 7

09-2292-00AB.fm Page 7 Wednesday, February 12, 2003 3:17 PM
click Configure to launch the configuration Web interface. Refer to the Access Point 8200/
8500 User Guide (included on the installation CD) for detailed information and instructions
on locating and configuring access points.
If you experience difficulty with the installation, see the Troubleshooting section of the
I
User Guide.
For the latest networking information, see the 3Com Corporation World Wide Web site:
http://www.3com.com/.
10 Regulatory Information
This product is in compliance with the essential requirements of Directive 1999/5/EC.
Channel Selection in France
In France, this product must be configured to operate on a legal channel. Channels 10 - 13 are allowed.
User documentation should be consulted to ensure that this product is used in accordance with local
spectrum restrictions.
Additional Country Restrictions
In Israel, this product must be configured to operate on a legal channel. Channels 5 - 7
I
are allowed.
In Jordan, this product must be configured to operate on a legal channel. Channels 10 - 13
I
are allowed.
User documentation should be consulted to ensure that this product is used in accordance with local
spectrum restrictions.
Safety Information
This equipment must be installed in compliance with local and national building codes, regulatory
restrictions, and FCC rules. For the safety of people and equipment, only professional network personnel
should install the access point, cables, and antennas.
WARNING: To comply with FCC radio frequency (RF) exposure limits, a minimum body-to-
antenna distance of 20cm must be maintained when the access point is operational.
WARNING: To avoid possible injury or damage to equipment, you must use either the
provided power supply or IEEE 802.3af compliant power supply equipment that is safety
certified according to UL, CSA, IEC, or other applicable national or international safety
requirements for the country of use. All references to power supply in this document refer
to equipment meeting these requirements.
WARNING: It is the responsibility of the installer to ensure that the Power-over-Ethernet
(POE) power supply is properly connected. Connection to any other device, such as a
standard Ethernet card or another POE supply, may result in permanent damage to
equipment, electric shock, or fire. Refer to the installation instructions for proper installation
WARNING: The 3Com power supply (part number 61-0107-000) input relies on a 16A
rated building fuse or circuit protector for short circuit protection of the line to neutral
conductors.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.