Bushranger 4x4 GEAR X-TRAX 54X07 Quick Start Manual

Basic Recovery
1.
Use a shovel to clear enough
area under wheel in the
direction of recovery.
Caution: Ensure vehicle is
stable.
Deep Recovery
1. Jack up vehicle so bogged
wheel is raised.
Small Steps/River Beds
1.
Move vehicle far enough
back from oversize rock to
allow safe work environment.
Once recovery is complete, grab the X-Trax II. Give them a little shake to remove any
Environment
Please take care in preserving the environment. Once vehicle is recovered, fill any holes
and ensure the surroundings are safe for next vehicle and returned to original condition.
X-TRAX
2. Place X-Trax II as far under that
side of the wheel, against the tyre.
Push the earth back under X-Trax II
to ensure it is touching the tyre.
Repeat for each bogged wheel.
2. Pack as much earth as possible
under wheel, lay down X-Trax II and
place tyre on top of end furthest
away from direction of travel.
Repeat for each bogged wheel.
2.
Unroll X-Trax II down the rock
surface, some smaller rocks may
be required for larger steps for
ease of climbing.
excess earth and fit them into their handy carry wrap for your next use.
Page 1 | X-Trax
54X07
3.
Using Low Range, slowly drive off
in the direction that you have
prepared and laid the X-Trax II.
At all times, avoid wheel spin on
X-Trax II.
3. Using Low Range, slowly drive off
in the direction that you have
prepared and laid the X-Trax II.
At all times, avoid wheel spin on
X-Trax II.
3.
Using Low Range, slowly drive off
in the direction that you have
prepared and laid the X-Trax II.
At all times, avoid wheel spin on
X-Trax II.